
Instructions
The center of mass in the F680e is in the middle of the sprayer. With shorter forklifts or when driving the forklift over rough
terrain while carrying the F680e, it is recommended to install the forklift stabilization kit 24Y479. These support brackets will
hold the F680e onto the forks and prevent the sprayer from falling, tipping, or bouncing off of the forks.
Tools Required:
• 9/16 in. wrench
Installation
1. Install the left bracket (1) and right bracket (2) and
loosely thread two screws (3) through each bracket.
Let the brackets rest on the ground.
2. Insert forks (F) under the rear back frame of the
sprayer and above the brackets resting on the ground
(see above left image).
3. Lift forks to contact bottom of the sprayer.
4. Slide left and right bracket up until they contact the
bottom of the forks.
5. Tighten all four screws (3) to secure brackets to frame.
WLD
NOTE: When lifting the unit, use a forklift
and always lift from the rear of the system.
F
3
2
1
3
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
Original instructions.
This manual contains English. MM 3A3181
Graco Headquarters: Minneapolis
International Offices: Belgium, China, Japan, Korea
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2014, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
www.graco.com
Revision A, August 2015