Graham's Fence Arlington Semi Privacy User manual

Arlington Semi Privacy Fence
INSTALLATION INSTRUCTIONS:
Required Tools:
Level, Measuring tape, Hacksaw, PVC glue, Shovel
Installation Procedures:
1. Post Installation
Dig a hole of 300mm wide and 860mm deep. The distance from hole center to center is 2.44m. Put post into the hole,
then fill the hole with concrete. Adjust the post level so the top of the post is 1880 above the finished ground level. We
recommend you use well braced string lines to get the line of posts level, straight and even height.
2. Fence Installation
Insert bottom rail in to post (with alum insert) by pushing it all the way into one, then slide it back into the other post until
the barbs on the rail snap into the holes. Put
panels into the slot of the bottom rail, making sure
panels with U-channel are on both ends.

3. Connect the Pickets
Insert the pickets into holes on both top rail and middle rail (big rail with holes). Make sure the notch is fully pushed inside
the post.
4. Final Installation
Slide top and middle rails complete with pickets into one post using the above method while lining up the panel to fit the
slot on the bottom of the middle rail. Then push the rails into holes on the post other post using the same method as above
again. Glue the caps to the post.