GrandTec Mega Pixel User manual

1
Grand Mega Pixel Wi-Fi Camera
QUICK GUIDE
1. Hardware Overview
2. Connecting to a Network
Connect the Grand Mega Pixel Wi-Fi Camera to an Ethernet hub or switch by using a
standard cable. You can also connect directly to a computer by using the cross-over wire
provided.
July 5, 09
3452100
2
3. Software Installation
Insert the driver CD into your CD-ROM drive, then the autorun function will start up the shell
program.
Step1: Press the Install Audio and Video Codec to install the audio and video codec.
Step2: Press the Install Mega Pixel IP Camera Viewer to install the surveillance software.
Step3: Press the Install IPCam Setup to install the IPCam Setup program.
Step4: The shortcut icons ( Mega Pixel IP Camera Viewer and IPCamSetup) will
be shown on your desktop after installing.
4. Network Installation
Step 1: Double click on ( ) IPCam Setup’s execution file on the desktop, and the following screen will
appear.
Step 2: Click the “Auto Detect” button, and your camera’s MAC and default IP Address will
be listed.

3
Step 3: Click on the “MAC”, and the “IP”, “Net Mask”, “Gateway”, “Port Number 1” and
“Camera Name” will be displayed in the “Network Setting” area.
NOTE: The IP Address, Net Mask and Gateway must be corresponding with your network
settings for you to access the camera. You can follow the steps to get your network
information.
Click “Start” →“All Programs” →“Accessories” →“Command Prompt”. A MS-DOS window
will appear. Type “ipconfig” and then press “Enter” to get your network information.
-Assign IP Address, Netmask (Subnet Mask) and Gateway (Default Gateway) for
the Mega Pixel Wi-Fi Camera. (You must use the same Net Mask (ex.
255.255.255.0) and Gateway (192.168.2.254). You can use any IP address
between 192.168.2.1-254, but make sure that the IP Address has never been used
or is used by another IP addressable device.)
Step 4: Directly modify the “IP Address”, “Net Mask” and “Gateway”, and click “Setup” to
save.
4
Step 5: Click the “Auto Detect” button again, and the new network information will be
shown.
Step 6: Select the “MAC” and click the “Connect” button to connect the Mega Pixel Wi-Fi
Camera.
Step 7: When the login screen appears, enter the user name and password (default user
name: root, default password: admin), and click the “OK” button to login your camera.
PS. Please consult the user manual in Driver CD for more detail.