Grizzly H8372 User manual

MODEL H8372
VARIABLE POWER
SPOTTING SCOPE
INSTRUCTIONS
COPYRIGHT © NOVEMBER, 2007 BY GRIZZLY INDUSTRIAL, INC., REVISED DECEMBER, 2013 (ST)
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#TS10175 PRINTED IN CHINA
Introduction
This high quality spotting scope is great for view-
ing wildlife and down range targets.
Inventory
After all the parts have been removed from the
box, use the Parts Breakdown on the back of
this page to inventory the parts.
Viewing the sun or any source of strong light
with this scope could cause temporary or
permanent damage to the eyes. Never use
this scope to view sources of strong light.
Specifications
Magnifying Power ........................................ 9–27
Objective Lens Diameter ........................... 50mm
Ocular Angle ...................................................45°
Tripod Mount Thread ..................................1⁄4"-20
Minimum Viewing Distance ......................... 20 ft.
Weight w/o Tripod, Caps, or Case ...........11⁄4 lbs.
Operation
1. Attach spotting scope to tripod.
2. Unscrew eyepiece lens cap from rubber eye-
cup, and remove objective lens cap.
Figure 1. Model H8372 components.
Tripod Mount
Rubber
Eyecup
Zoom
Ring Focus
Ring
Objective
Lens
Sun
Shade
Note: The edge of the rubber eyecup (see
Figure 1) can be folded down to view the full
field when wearing eyeglasses.
3. To focus, slowly rotate focus ring until object
becomes clear.
Note: The minimum viewing distance is
approximately 20 feet.
4. Change magnification by rotating zoom ring.
Note: You may need to re-focus after chang-
ing magnification.

Care & Storage
When not in use, install the eyepiece and objec-
tive lens caps and place the scope in the protec-
tive case. Store the scope and tripod in a dry,
room-temperature environment.
NOTICE
Natural skin oil can permanently damage
the lens coating, causing a reduction in
viewing quality. Never touch the lenses with
your fingers.
Cleaning
Use compressed air or a lens brush to remove
any dust or debris from the lenses. To remove
dirt from the lenses, use a soft, clean cotton cloth
and lightly rub in a circular motion from the center
outward. For a more thorough cleaning, apply
a photographic-type lens fluid to the cleaning
cloth—not directly on the lens.
NOTICE
Using coarse fiber cloth or any paper prod-
uct can permanently scratch the lens sur-
face. Use only soft, cotton cloth to clean
the lenses.
If you need help with your new item, call our Tech
Support at: [phone].
12
3
4
5
6
Parts Breakdown & List
REF PART # DESCRIPTION REF PART # DESCRIPTION
1 PH8372001 SPOTTING SCOPE 9-27X50MM 4 PH8372004 EYEPIECE CAP
2 PH8372002 RUBBER EYECUP 5 PH8372005 OBJECTIVE LENS CAP
3 PH8372003 TRIPOD 6 PH8372006 PROTECTIVE CASE