GrowlerWerks uKeg Nitro User manual

1
Owner’s Manual
12 CUPS

2
IMPORTANT NOTES
Do not open
sleeve when
cartidge contains
pressure.
Do not use
uKeg with liquids
above 120
degrees F.
Do not turn off
pressure when
uKeg is full. Doing
this does not
save nitro gas.
Do not use
abrasive materials
or metal polish on
coatings.
Do not put in
dishwasher. HAND
WASH ONLY.
Additional Accessories Available at GrowlerWerks.com
FOR SAFETY AND OPTIMAL PERFORMANCE WARNING!
DO NOT put hot water
in the uKeg Nitro. Using
hot water in the uKeg
can result in serious
injury and/or damage to
the product.
Welcome to your new uKeg Nitro Cold Brew
Coffee Maker! Now you can MAKE, STORE
and POUR nitro cold brew coffee wherever
life takes you. This manual will help you keep
the uKeg Nitro in perfect working order and
will give you helpful tips to be your own
professional barista!
For more info, please visit:
www.growlerwerks.com

3
UKEG NITRO BASICS
Install Cartridge
• Before filling.
• Ensure dial is in off
position.
Charge Cap
• Tighten sleeve quickly
and firmly.
• Sleeve does not need
to bottom out.
• A quick puff of gas is
normal.
1 . 2 .
OTHER TIPS:
• Turn on pressure right away after filling.
• After dispensing, use remaining gas to flush uKeg.
• For best performance, we recommended GrowlerWerks
brand Nitro Gas.
e Cap
The dial controls the
pressure inside the uKeg
Nitro.
• Turn to “Infuse” for nitro
infusion.
• Turn to “Pour” for best
best performance
while pouring and
storing.
e Tap
• Fold tap handle back
to lock.
• Pull forward to pour.
• ENJOY!
INSTALLING THE NITRO GAS CARTIDGE ADJUSTING PRESSURE LOCKING TAP

4
BREWING NITRO COLD BREW
• FIll 2 bags with 60g
(~3/4 cup) with
course ground coffee
each.
• Tie knot with bag
strings.
1 . 2 .
• Place both bags in
uKeg (knot facing
upward).
• Fill with water to
“Brew” Line (~1.25
liters).
3 .
• Place in refrigerator
for 12-24 hours.
4 .
• Pull out bags.
• Add additional water
to “Fill” line (~.75 liters).
5 .
• Charge cap with
a fresh nitro gas
cartridge.
• Tighten cap on uKeg
Nitro.
• Turn dial to “Infuse”.
• Shake for 1 minute to
infuse nitro gas in the
cold brew.
• Turn dial to “Pour”
• Serve and ENJOY!
8 .
2 .1.
7 . 6 .
BREWING NITRO COLD BREW
4 .
PRO TIPS
For a Stronger Cold Brew:
• Use more coffee. Each bag can hold up to 1 cup.
• Brew longer (up to 24 hours).
• In step #3, fill with water above the “Fill” line. This
leaves less dilution water to add later.
For a More Nitro Infused Cold Brew:
• Make sure your brew is as cold as possible before
infusion (use some ice in step #5 when diluting).
• Shake longer
• Leave the pressure setting on “Infuse” overnight.
For more pro tips, visit: www.growlerwerks.com

5
CLEANING YOUR UKEG
• Turn off gas.
• Remove cap and
rinse with warm
water. (less than 120
degress F).
1 . 3 .
• Discharge remaining
nitro gas by turning
dial and venting.
• Remove and recycle
gas cartridge.
4 .
• Fill with warm water
under 120 degress F
and 1 cleaning tablet.
• Cap and shake well.
• Baking soda is a
suitable substitute.
• Install cap, charge
briefly with left-over
nitro gas, flow water
through tap and
close tap.
• Let sit 10 minutes.
• Open tap until
pressure runs out.
• Remove the nozzle
for cleaning and
drying.
• Rinse (make sure
parts inside nozel
remain intact).
• Allow to dry
by pouring out
remaining water.
• Store with cap off
and tap open in dry
place.
5 .
uKeg
Cleaning Tablets
Available At
GrowlerWerks.com
1 . 2 . 3 .
AFTER EACH USE
FOR A MORE THOROUGH CLEANING
• Install cap.
• Use remaining nitro
gas to flow water
through tap.
• Close tap.
• Rinse uKeg with
warm water.
• Repeat 2-3 times
until clean.
2 .