H2O TriniT User manual

ASSEMBLY AND INSTRUCTION
INSTRUCTION
3 IN 1 STEAMING HOT WATER TAP
The 3 in 1 steaming hot water tap is suitable for dispensing steaming
hot water (98°C) and purified water.The steaming hot water hose of
the steaming hot water tap be directly connected to the heating tank.

PRODUCT DIMENSION DRAWING
Faucet
265mm
195mm
195mm
Notice:suitable for fitment to work surfaces / sinks and tops of 60mm depth max.

INTALLATION OF 3-IN -1 STEAMING HOT WATER TAP
(Accessories)
O-ring
Adaptor
(for steaming hot water)
Adaptor
(for filtered water)
Adaptor
(3/8 to 1/4)
6.4mm Push Fit
Clear Silicon Hose
Tube

INSTALLATION OF 3-IN-1 STEAMING HOT WATER TAP

* See the view of faucet bottom
*Install the couping nut on the boiling water hose
* Firstly, remove 4pcs of locking nut; and then please pass the 6.4mm push fit tube /clear silicon hose through
the nuts, Finally, Please connect each tube to the tap and tighten the nut on the tap,as shown in Step 6~8.

Step 3 - Connect Faucet to Tank
Filtered Water In
Steaming Hot Water Out
Indicator Light
(Red:Heating,
Green :Steaming
Hot Water)
98°C
90°C
OFF
Indicator Light
(Red:OFF,
Green:ON)
OFF
ON
A
a
B
b
Adaptor
O-ring
Adaptor
O-ring
Put O-ring in the Adaptor.
When you tighten the nut, use a wrench to hold the
water pipe so that the water pipe will not be damaged.
Please hold the water pipe until the nut is tightened
(Do Not Overtighten)
1
2
3
4

Step 3 - Connect Faucet to Tank
We advise that the filter is to be changed every 6 / 8
month depending on usage , to prevent any issues with
water flow, lime scale /water debris build up.
Tank
Adaptor(3/8 To 1/4)
(Filtered water in)
(boiling water in)

Step 4 - Check For Leaks
Step 5 - Prepare For Test
1: Open valve in water line.
3: Turn faucet off. Check for leaks.
2: Turn boiling water handle on to fill tank (about 1 minute). When tank is full,
water will flow from faucet , as shown in Figure 4.
1:Plug electrical cord into a grounded 3-prong outlet.
2: Turn on the button on the right, then set the temperature to 98°C/90°C ,
98°C/90°C will be reached in about 10 minutes, as shown in Figure 5.
The green light indicates that the water is boiling , the red light indicates
that it is heating.
Figure 5
Figure 4
Tank
98 °C
OFF
OFF
ON
90 °C

Step 6 - Test Installation
Caution:
The temperature of the
watercan reach 98°C
therefore care must be
taken to avoid scalding
98°
Notice: If the tank usage is taken to the limit the red light will re-appear on the tank
as the amount of Steaming water has been used and the tank needs to refill and re-heat
to the set temperature
Boiling water
Handle
Purified Water
Handle
Tank
Adaptor(3/8 To 1/4)