H&A TQ-LT1203 User manual

USER MANUAL
PROFESSIONAL SPEAKER
PLEASE READ THIS USER MANUAL CAREFULLY BEFORE SYSTEM CONNECT
MADE IN CHINA
TQ-LT1203 / TQ-LT1204
TQ-LT1502 / TQ-LT1503
TQ-LT1502 TQ-LT1503
Before using this machine, please read all the safety and operating instructions,
meanwhile, please observe all the indications about safe operating. These safety and
operating instructions should be kept in condition of consultation.
1. Protection of electric power supply line: Be aware that the electric power supply line is not
tramped, pressed by heavy objects. Pay special attention to the plug of power supply line and outlet
on the machine. DO NOT lengthen the electric shock, DO NOT pull or drag or the power supply line.
2. Ventilation: This set must be put in ventilated place. DO NOT put disk on it or cloth to cover it. The
distance away from the wall should not be less than 10 centimeters. DO NOT put this set on the bed,
sofa, carpet or other objects with similar surface in case of good ventilation.
3. Casing Dismantling: DO NOT dismantle the casing . If one touches the inner components, he will
probably get serious electric shock.
4. Unusual smell: When you discover unusual smell and smoke, cut power supplies immediately and
pulls out the plus from the outlet on the wall. Contact the sell shop or nearest repairing center.
Attention: This set applies to AC 110V~240V / 50Hz~60Hz power supply. Use standard power supply.
Please be sure for te correct power supply before use it.
IMPORTANT SAFETY MEASURES
REAR PANEL FUNCTION INSTRUCTION
PRODUCT FEATURES
WIRELESS INSTRUCTION
Change the mode into “BLUC”, the wireless sign light twinkles, and
speaker have sound “di”. Set on mobile phone, connect to wireless
data, search equipment and match properly. The proper connect
wireless lights keep on, and music work on speaker normally.
CONNECTING
1. This set applies to AC 100V-240V, 50/60Hz
2. AC power: battery can be charged when connected to AC power.
Red light on battery is charging, it will change to green once bat-
tery complete charge.
3. Internal battery will be charged even device switch off when plu-
gged in to AC power
4. Speaker battery can be charged using 12V external car battery
as well(connect cable not included) by "DC 12V input". Please
make sure "+" and "-" in right connection.
5. Adjust function keys to your personal audio preference.
●Wireless
●Plays Mp3 files stored in SDC card/USBC drive/external audio
device.
●FM radio ●Guitar input ●Microphone inputs
●Wireless microphone included ●With remote control
●Built-in rechargeable battery ●Super dynamic sound speaker
BATTERY & CHARGING
1. The units takes approximately 8 hours to fully charge. It will
automatically begin charging once the power cord is connected.
2. If the battery power is low may caused sound distortion or stop
play, please charging the battery on time.
3. To maximize the battery's lifespan, please charging the battery
immediately. When the unit is not used for prolonged periods of
time,the battery will gradually lose its power. It is recommended
to fully charge the battery at least every 30days.
4. To saving battery, please power off once stop using.
148.5mm 148.5mm
148.5mm 148.5mm
210mm 210mm
REMOTE CONTROL
Standby
USBC/SDC/LINE (Audio input)
Prev/FM CH-
Play/pause/FM tuner
Next/FM CH+
Repeat
Stop
Volume up
Volume down
Mute
Equalizer
Number
TQ-LT1203 TQ-LT1204

FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/ TV technician for help.