Hanss PA-23 User manual

MC/MM PHONO AMPLIFIER
Instructions for use
PA-23
The manufacturer accepts no responsibility for damage
caused by not adhering to these instructions for use.
Modification or change to any part of the product by
unauthorized persons release the manufacturer from any
liability over and above the lawful rights of the customer.
Warranty
HANSS ACOUSTICS
E-mail:
Website: http://www.hanss-acoustics.com
[e-mail]

Dear music lover,
Thank you for purchasing HANSS ACOUSTICS PA-23.
Connecting the turntable
Connect the tonearm signal cable to the IN of the phono
amplifier, make sure to connect the left and right channels
correctly . The right channel is usually marked in red & the
left channel black or white . The earthing wire of the tonearm
lead should be connected to the GND terminal .
Connecting the amplifier
Connect the Out of the phono amplifier to a line input (such
as AUX, CD, TAPE or VIDEO )on your amplifier.
Take care to connect left and right channels correctly . The
right channel is usually marked red , the left channel black or
white.
MC MM
PA-23
AC POWER
SN:
GND
Pre/integrated Amplifier
MC input
Sensitivity : 0.35mV for 350mV output at 1KHz
Input impedance : 200 Ohms
S/N ratio : >85dB unwweighted
MM input
Sensitivity : 0.35mV for 350mV output at 1KHz
Input impedance : 47K Ohms
S/N ratio : >98dB unwweighted
General
RIAA accuracy : ±0.25dB 20Hz to 20KHz
Power : AC 17V~ 50/60Hz
: 8VA
Dimensions : 220*190*70 mm
Weight : 3.1 kg