Reflex furler
6
Snap shackle D-shackle Diam Line ht. Tack swivel Hole top Thimble top Hole bottom Thimble bot. Clamp ht.
A A B C D E F H I J
UNIT 1
7351.10 Reflex furling system - Asymmetric spinnakers
55 mm 28 mm 140 mm 54 mm 94 mm 114 mm 131mm 53 mm 83 mm 50 mm
2.16" 1.12" 5.5" 2.13" 3.7" 4.5" 5.17" 2.08" 3.27" 1.97"
7361.10 Reflex furling system - Code zero sails
55 mm 28 mm 140 mm 54 mm 103 mm 120 mm 53 mm 83 mm 50 mm
2.16" 1.12" 5.5" 2.13" 4.04" 4.71" 2.08" 3.27" 1.97"
UNIT 2
7352.10 Reflex furling system - Asymmetric spinnakers
61 mm 38 mm 167 mm 64 111 mm 134 mm 152 mm 76 mm 93 mm 60 mm
2.41" 1.49" 6.59" 2.52" 4.35" 5.28" 5.97" 2.98" 3.67" 2.36"
7362.10 Reflex furling system - Code zero sails
61 mm 38 mm 167 mm 64 121 mm 138 mm 76 mm 93 mm 60 mm
2.41" 1.49" 6.59" 2.52" 4.76" 5.47" 2.98" 3.67" 2.36"
*
A A A
C D E E
H I
J
Dimensions - Sailmakers's Instructions
Luff length - asymmetric spinnaker
Note offset H at the top and offset D at the bottom. When using system
for asymmetric spinnakers, D represents the attachment point to the tack
swivel terminal.
Luff length - code zero
Note offset H at the top and offset E at the bottom representing the
attachment points for the sail cloth.
Code zero luff cable
The Reflex torsion cable is designed for use with asymmetric sails and
transmits torque at lower halyard loads. When using the Reflex torsion
cable with a code zero sail, make sure there is an additional rope to handle
tension. Alternatively, use a tension receiving rope that is torsionally
resistant and splice it to the thimble in the head swivel and the fixed tack
terminal. This alternate method will require more tension to furl, making
furling more difficult.
IMPORTANT! When using a 2:1 tack line, remember that it is pulling
against the halyard. Downsize the diameter of the 2:1 tack line so
that it does not overpower the stretch of the halyard.
F
F
Fixed tack terminal
for code zero sails
Threaded adapters
Tack swivel terminal for
asymmetric spinnakers
