Harrod Sport TEN-517 User manual

TEN-517
Tennis Training Frame and Net
INS639
Revison 4
31/07/13
Harrod UK Limited©
Code:
Product:
Note one incline
adjuster arm
the
frame, the other
arm
outside
inside.
Fig.2
10
12
2.2m (7’2”)
2.7m (8’10”)
11
Fig.1
3 foot or
914mm =
regulation
height of Tennis
Net at centre.
1. 2 x 1060mm Double Swaged Tube (no holes) (SEP443)
2. 4 x 890x200mm Bent Corner Tube ( (SEP446)
3. 2 x 1060mm Double Swaged Tube (1 hole) (SEP441)
4. 2 x 1030mm Single Swaged Tube (1 hole) (SEP442)
5. 2 x 850mm Plain Tube (1 hole) (SEP445)
6. 2 x 850mm Adjuster Tube (5 holes) (SEP444)
7. 2 x 1060mm Double Swaged Tube (3 holes) (SEP447)
8. 2 x 890x200mm
9. 1 x 1060mm
no holes)
Bent Corner Tube (2 holes) (SEP448)
Double Swaged Tube (2 holes) (SEP435)
Pack Contents:
Pack Contents
View of Product
10. 1 x Net Top Indicator Band (BAN149)
11. 4 x Elastic cords (ELA001)
12. 1 x Net (TEN-076)
Fittings Pack contents (FPK008)
13. M6 x 70mm Bolt x 6 (BOL609)
14. M6 Nylock Nut x 4 (BOL602)
15. M6 Wing-Nut x 2 (BOL603)
16. Black Plastic End Cap x 6 (CAP330)

TEN-517
Tennis Training Frame and Net
Code:
Product:
Assembly Instructions
3
2
13
16
16
16
14
15
14
13
13
8
8
2
9
5
4
1
3
1Using the ‘Pack Contents’table, identify the parts and lay them out ready to assemble.
2Assemble the frame by pushing the tubes together and using the bolts and nuts to join the
front frame and the incline adjuster frame together, as shown in Fig. 3.
The incline adjuster frame is held together with spring clips and the main frame will be held
together once the net is fitted.
3When the frame is fully assembled and the nuts and bolts are fully tightened, if you can not
reach the top of the frame, lay the frame down on the ground to attach the net. Two or more
people are required to do this, as the frame is heavy and awkward when assembled. It is
advisable to wear gloves to thread the elastic, as it requires tension. Starting in the centre of a
long side of the frame, thread the first of the elastic cords around the frame, (hook each length
together as used) and in through every other mesh of the net, as shown Fig.1. Secure each corner
with the elastic as shown in Fig.2. Upon reaching the end of the cord, hook onto an additional
cord and continue to tie the net as before. Repeat until all cord have been utilised and the net is
fixed all round. Tension so that there is a gap between frame and net of about 5” on the long
sides, and about 3” on the short sides.
Fig.3
4Now that the frame and net are fully assembled, gently tap the black plastic inside fitting
caps into place, as shown Fig.3. The ‘Net Top Indicator’can be threaded through the meshes
as a target height, as shown Fig.1. Ref height 3’ or 914mm = regulation height of Tennis Net at
centre.
7
7
PRESS
BUTTON
DOWN
INSERT SWAGE
INTO TUBE