Havis C-ARPB-101 Guide


  
  C‐ARPB‐101_INST_5‐16






















INSTALLATION – ASSEMBLY INSTRUCTIONS
BROTHER / PENTAX POCKET JET
PRINTER / ARM REST MOUNTS
Models - C-ARPB-101, 102, 103 and 110
TOOLSREQUIRED:
PhillipsScrewdriver ¼DriveRatchetwrench SocketSet
PARTSandMOUNTINGHARDWARE:

QTY DESCRIPTIONPART#

1PentaxPrintermountHousingC‐PM‐101
(PrinterHousingtoArmrestbracket)
4¼x¾”CarriageBoltGSM32000
4¼NylockNutGSM30016
4¼FlatWasherGSM31005
1AntirollbracketCM005189
1ArmRestandbracketassemblyC‐ARM‐103,104or105
(HardwareforBrackettoConsoleorTunnelMountExtrusion)
4¼x½PPHMS GSM33123
4¼NutGSM30005
4¼FlatWasherGSM31005

1ReinforcementPlate(forArmPad)CM007618
(ArmPadtoPrinterHousing)
4 ¼”x¾”PhillipsflatheadmachinescrewGSM33087
2¼x½”CarriageBoltGSM31999
2¼”NylocknutGSM30016‐1
Always!
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wires, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit



  
  C‐ARPB‐101_INST_5‐16





















C-ARPB-101, 102, 103 and 110
ASSEMBLY DRAWING
CM007618
Reinforcement Plate
Arm Pad from C-ARM-XXX
C-ARM-103
Console Mount
Arm Rest Bracket
C-PM-101
Printer Mount Housing
C-ARM-104
Platform
Arm Rest Bracket
C-ARM-105
Side Mount
Arm Rest Bracke
t
EndCapandfour
(4)selfthreading
screws
¼x¾”CarriageBolts&nuts(notshown)
Forattachingprintermounthousingto
flipuparmrestbracket
ArmPad
¼x¾Flathead
machinescrews
Anti‐rollbracket
CM005189
Two(2)¼x½”Carriagebolts
and¼”Nylocknuts


  
  C‐ARPB‐101_INST_5‐16


Installation and Assembly Notes:
C-ARPB-110 does not have a C-ARM Bracket
1. Remove one end cap from the extruded printer housing.
2. Place Pentax printer into extruded housing and connect wires.
3. Reattach printer housing end cap.
4. Bolt the complete Arm Rest Printer Mount assembly to the console sides
or flat surface as desired with ¼ x ½ bolts, nuts and flat washers.
The examples below show some completely assembled mounts.





  
  C‐ARPB‐101_INST_5‐16



C‐ARPB‐110
FlatSurfacemount
C‐ARPB‐102
TunnelorFlatPlatformmount
C‐ARPB‐103
Sidemount
C‐ARPB‐101
Consolemount
C‐ARPB‐102shownin aFordCrownVictoria.
ThearmrestbracketisboltedtoaC‐TMW‐CV‐01TunnelMount.