Hedstrom SATURN M08602 User manual

17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
SAFETY GUIDELINES
SWING PARTS LIST
SATURN - M08602
FOR CHILDREN AGED 3 TO 10 YEARS
Not suitable for children under three years, contains small parts.
This equipment must be assembled and checked by an adult. Two adults may be required to assemble this product.
For family domestic use only. This product has not been designed for commercial use in play centers, nurseries etc.
Adult supervision is required at all times.
Only one child per seat at any one time.
The item is not designed for adults or for children weighing more than 45kg.
The total weight on the product at any one time must not exceed 145kg.
For outdoor use.
Check all nuts, bolts and fittings for tightness and tighten if required.
Check all coverings for bolts and sharp edges and replace when required.
Check swing seats, chain, ropes and other means of attachments if relevant to your product for evidence of deteriora-
tion. Replace when required in accordance with the manufacturers instructions if necessary.
Place the product on level surface at least 2 metres from any structure or obstruction such as a fence, garage, house,
wall, overhanging branches, laundry line or electrical wires.
The items MUST be anchored firmly into the ground.
DO NOT install the product over concrete, asphalt or any hard surface.
DO NOT orientate the product directly towards the sun.
Leave all fittings finger tight until assembly is complete, for ease of construction. Then tighten firmly.
Children should not wear cycle helmets whilst on this equipment.
Do not allow children to stand on any swing seats, glider seats or slide chutes relevant to your product.
Do not allow the children to jump or climb off any moving equipment.
Do not twist swing ropes or wrap them over the top bar.
Do not allow loose, hooded or baggy clothes to be worn as children can get trapped and may be unable to free
themselves.
Do not allow children to climb on parts of this equipment intended for this purpose.
Do not allow children to wander into the play area whilst the equipment is in use.
Do not allow children to slide head first down the chute, walk up the chute or jump or climb off the chute.
Gliders and swings must not exceed an angle of 60 degrees from the ground.
Regularly check the item for wear and damage, removing the item from use when necessary until replacement parts
are fitted.
Failure to assemble and maintain this item as per instruction may cause injury to the user.
Please keep the instructions in a safe place for future reference.
Made in China to European Standards.
Conforms to EN71
“left-hand” type top leg (x2)top bar (x1)
swing seat (x1)
spanner (x1)allen key (x1)
“right-hand” type top leg (x2)
side stay bar (x2)
plain bottom leg (x3)
glider legs (x2)
glider bracket (x1)
glider seat (x2) glider footrest (x2)
glider seat tubes (x2)
2
4
56
11 12
89 10
glider handle tubes (x2)
7
1
3
14 15
13
SLIDE PARTS LIST
bottom leg (x1)
03.07 ISSUE 1
ground peg (x5)
16
33 chute support top bar x1
chute side stay bar x1

2
1
3
F1
STEP 1
Frame & Swing Assembly
STEP 2
Glider Assembly
F2
F1
15
14
M8 BOLT 53mm (x2)
M6 BOLT 47mm (x4)
M8 U BOLT (x2)
ALLEN KEY
SPANNER G1 M6 BOLT 42mm (x2)
G2
G8
M8 BOLT 39mm (x2)
THIN PLASTIC SPACER (x4)
S1
661
1
7
G8
G8
G2
G1
• Remember to attach the rope clamp to the U bolt
• Ensure bottom leg (10) is connected to top leg (2) and not top leg (3)"
rope clamp
1
S1
13
IMPORTANT: Make sure you read the safety notice on the front page and always supervise
children while they are playing on the equipment. Once assembly is completed carefully check
equipment. In the unlikely event that you do find any problems, please contact us. Do not allow
children to use this product until the problem has been corrected.
1
2
10 2
3
4
23
26
27
4
4
5
6
7
8
9
11 12
13
18
19
20
23
22
24
25
21
2
5
5
5
4
4
4
10
5
4
3
3
2
2
1
F2
3

G6 M6 BOLT 35mm (x2)
G6
G4
G5
G9
M6 BOLT 35mm (x8)
M6 BOLT 40mm (x2)
M8 BOLT 82mm (x2)
THICK PLASTIC SPACER (x4)
16
7
7
8
8
8
G6
G6
G9
G4
G5
9
12
11
• Assemble seats (11) and attach to seat tubes (9) before tightening bolts (G4)
STEP 3
Wavy Chute Assembly Continued
C2 M6 BOLT 45mm (x4)
C3 M6 BOLT 40mm (x6)
C4 M6 BOLT 35mm (x1)
C4 M6 BOLT 35mm (x4)
Bottom of Chute
Top of Chute
32 28
30
25
29
33
31
33 C4
C4
STEP 3
Wavy Chute Assembly
C4 M6 BOLT 35mm (x6)
Top of Chute
Bottom of Chute
33
28
30
31
C4
17
17
C5 M6 BOLT 30mm (x2)
33
C5
17
17

G6 M6 BOLT 35mm (x2)
G6
G4
G5
G9
M6 BOLT 35mm (x8)
M6 BOLT 40mm (x2)
M8 BOLT 82mm (x2)
THICK PLASTIC SPACER (x4)
16
7
7
8
8
8
G6
G6
G9
G4
G5
9
12
11
• Assemble seats (11) and attach to seat tubes (9) before tightening bolts (G4)
STEP 3
Wavy Chute Assembly Continued
C2 M6 BOLT 45mm (x4)
C3 M6 BOLT 40mm (x6)
C4 M6 BOLT 35mm (x1)
C4 M6 BOLT 35mm (x4)
Bottom of Chute
Top of Chute
32 28
30
25
29
33
31
33 C4
C4
STEP 3
Wavy Chute Assembly
C4 M6 BOLT 35mm (x6)
Top of Chute
Bottom of Chute
33
28
30
31
C4
17
17
C5 M6 BOLT 30mm (x2)
33
C5
17
17

STEP 3
Anchoring the Gym to the ground
IMPORTANT: For safety reasons this gym MUST be anchored into the ground.
We recommend that it is concreted in. If you are uncertain about this procedure,
telephone our helpline number.
P1 M6 BOLT 58mm (x4)
P2 M6 BOLT 47mm (x1)
CUSTOMER SERVICES
MV has taken great care to ensure that this toy has reached
you in good condition. Should you have a query, please contact:
customer[email protected] where your query will be
dealt with promptly. Alternatively, you can call on 0870 8404255.
MV Sports & Leisure Ltd.
35 Tameside Drive
Castle Bromwich
Birmingham B35 7AG
United Kingdom
email: [email protected]
www.mvsports.com
C1
C4 M6 BOLT 35mm (x2)
M6 BOLT 58mm (x2)
• Please assemble tube 22 Last
• Leave the bolts loose until the chute is assembled
to the ladder frame, to ease construction. then tighten firmly
2
5
277
26
27
18
23
24
25
26
18
25
33
29
23
26
24
22
24
19
20
21
10
17
18
C4
C3
C3
C3
C3
C3
C2
C3
C1
4
16 16
16
10
4 10
24 24
P1
P2
C2
C2
C2
C4