Hercke 7EVEN Series User manual

ASSEMBLY INSTRUCTIONS
Platforms
Stationary, Rolling
INSTRUCCIONES DE MONTAJE Bases de Plataformas Inmóvil, Rodante
INSTRUCTIONS D’ASSEMBLÉE Bases de Plate-forme Immobile, Roulante

A Phillips head N0. 2 screwdriver is the
only tool required to assemble Hercke®
Series 7even®products. Depending on
your installation requirements, other tools
that may be helpful include a level, power
drill and drill bits.
1
Assemble all platforms. Place platform in
the desired location. Level each platform
and make sure all platforms are level
together.
2
Assemble Overhead Storage Cases.
Select overhead cabinet placement.
Attach case using Wall Mount System or
Channel Mount System.
4
Fasten Single and Double E-Clips to
adjoin cases and drawer modules.
5
Snap door hinges to case hinge plates
and adjust door positions.
6
Attach work surface.
Chaos Defeated. Order Restored.
7
Pull platform out allowing yourself room to
get behind the platform. Assemble cases.
Stack cases and drawers on platforms in
a single stack. Add Single E-Clips to the
backside of cases and drawers. Slide the
stack back into their final level position.
3
Please read this brief overview before assembling your Hercke Series 7even system. What follows
is an outline of the order in which your assembly process needs to occur.
Assembly Instructions Overview

AAssemble legs
BFasten legs to platform frame using parts & in the outer round hole as illustrated below.
CInsert screws into the holes on the sides of the platform frame. (These will later be used with E-Clips and
Double E-Clips to secure cabinets to the platform.)
Rotate legs to adjust height and level platform.
ADJUSTABLE STATIONARY PLATFORM
1
2
PARTS
x1pcs
Platform Frame
Ax4pcs
Legs
B
E
x4pcs
Leg Screws
5/16”-18 x 3/4”
#2 Phillips Pan Head
Machine Screw
Cx4pcs
5/16” Split
Lock Washer
Dx8pcs
Rod Screw
1/4”-20 x 3/4”
#2 Phillips Pan Head
Machine Screw
E
B
B
A C D
E
D
B
C
A
B
B
B
B
Leg Assembly
B
A

www.hercke.com | 866.767.3905 ext.16
Please visit www.hercke.com to download these instructions in your preferred language.
© Copyright 2008 Hercke International. All rights reserved. Hercke®, Series 7even®, System 7even.1®, System 7even.2®, and System 7even.3® are registered trademarks of Hercke International.
PARTS LOCKING ROLLING PLATFORM
AFasten casters & to platform frame using parts & as illustrated below. Make sure the caster posts
are placed and seated in the hex hole. Place both rolling casters on the back side of the platform and both of the
locking casters on the front side of the platform.
BInsert screws into the holes on the sides of the platform frame. (These will later be used with E-Clips and Double
E-Clips to secure cabinets to the platform.)
1
2
B A
A
B
D E FC
C
C
C
B
B
x1pcs
Platform Frame
Ax4pcs
Hex Nut
M12 x 1.75
D
x2pcs
Caster
C
x4pcs
Split Lock Washer
12mm
E
x2pcs
Locking Caster
B
x1pcs
Wrench
Fx8pcs
Rod Screw
1/4”-20 x 3/4”
#2 Phillips Pan Head
Machine Screw
G
A
F
F
D
E
G
G