RH MAISON SHELTER QUEEN BED User manual

PARTS INCLUDED HARDWARE INCLUDED
ASSEMBLY INSTRUCTIONS
1. Lay the headboard (A) on a flat surface, then attach the legs (F) to the
bottom of the headboard by turning them manually. Repeat this step to
attach the legs to the footboard (C). See FIGURE 1.
2. Place the headboard upright in the location you wish the bed to be in when
fully assembled.
3. Secure the threaded rod (1) to the fixed nut on the headboard by simply
turning manually.
4. Raise the side rail (B) and place the rod to align with the holes on the end of
the side rail. Position the side rail against the headboard so the threaded
rods go through the holes. Insert curved washer (2), lock washer (3) and
hex nuts (4) on the threaded rod, then tighten the hex nuts with the wrench
(5), as shown in FIGURE 2.
5. Repeat the above procedure with the other side rail to attach it to the
headboard, and then repeat to connect side rails to the footboard.
A
B
C
D
E
F
[1]
[2]
[1]
[7]
[1]
[4]
HEADBOARD
SIDE RAILS
FOOTBOARD
BED SLATS
SUPPORT SLAT
LEGS
1
2
3
4
NO. ITEM DESCRIPTION QTY.
Lock Washer
Allen Wrench 1 pc.
Wrench
Threaded Rod
Curved Washer
Hex Nut
1 pc.
8 pcs.
8 pcs.
8 pcs.
8 pcs.
5
6
FIGURE 1
FIGURE 2
Page 1 of 3
MAISON SHELTER QUEEN BED WITH FOOTBOARD INSTRUCTIONS
11/1/18

MAISON SHELTER QUEEN BED WITH FOOTBOARD INSTRUCTIONS
6.
7.
8.
On the inside of both headboard and footboard are pre-installed wooden brackets
for the support slat (E). Set the support slat on the wood bracket, as shown in
FIGURE 3.
On inside surface of both side rails are cavities designed to hold the individual bed
slats (D). Set individual slats on both sides of the side rail, as shown in FIGURE 4.
Assembly is complete.
FIGURE 3
FIGURE 4
Maison Shelter Bed - Page 2 of 311/1/18

MAISON SHELTER QUEEN BED WITH FOOTBOARD INSTRUCTIONS
FIGURE 5
FIGURE 6
Maison Shelter Bed - Page 3 of 3
OPTION WITHOUT SLATS
9.
10.
11.
If you want to use the bed without the slats, start by following steps #1 - #5.
Remove the support rail installed on the side rail, using the Allen wrench (6) to
loosen the bolts installed on the rail. Refer to FIGURE 5.
Remove the wood brackets installed on the headboard and footboard, using the
Allen Wrench to loosen the bolts installed on the bracket. Refer to FIGURE 6.
CARE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
1. Dust often using a clean, soft, dry and lint-free cloth.
2. Blot spills immediately and wipe with a clean, damp cloth.
3. We do not recommend the use of chemical cleansers, abrasives, or furniture polish on our lacquered finish.
1. Please read all instructions carefully before assembling.
2. For your safety, assembly by two or more adults is strongly recommended.
3. Keep these instructions for future use.
4. Use only vendor-supplied hardware to assemble. Using unauthorized hardware could jeopardize the structural integrity of the
item.
11/1/18