Herma 2C Hang It User manual

Factory 4a, 6 Albert Street Preston Vic 3072 Australia
Phone: [phone] Fax: [phone]
Email: [e-mail] Web: www.2cdisplays.com.au

2C Hang It (Wall) Instruction Manual
www.2cdisplays.com.au

www.2cdisplays.com.au | 1
Unpacking Wallmount
Spring
4 x long Skyhook arms
Wallmount unit
(pre-assembled)
1 x Pivot knuckle
(pre-assembled)
U-BracketMounting bolts,
springs and washers
Attaching to Projector
Washer
Tighten Nut
Locate u-bracket to the
center of the projector
once xed; tighten all
bolts.
Tighten
Bolt:
M4,M5 or M6
Tighten after assembled
Small M8 Washer
Large Washer
Coach Bolt Line up Skyhook
arms with Projector
mounting holes.
M8 Nut

www.2cdisplays.com.au | 2
Information in this document is subject to change without notice.
© 2002-2010 Herma Technologies. All rights reserved.
Reproduction in any manner whatsoever without permission of Herma Technologies is
strictly forbidden.
Trademarks used in this text: Herma, the Herma Logo, and LP Morgan logo are registered
trademarks of Herma Technologies. Other trademarks and trade names may be used in this
document to refer to either the entities claiming the marks and names or their product.
Herma Technologies disclaims interest in trademarks and trade names other than its own.
Mar 2010 Version 1.1
Wallmount Installation
Secure the mounting plate
and pivot knuckle to wall with
appropriate fasteners.
Hook skyhook onto pivot
knuckle, secure with 4 x
M6 bolts.
Attach here
Adjust position (pan/tilt/yaw). Lock
off 8 x M6 bolts.
Pan
Installation completed, enjoy the show.
Yaw


15°
15° 360°
0°
0°
Adjust here
Tilt