hinor i5 line User manual

MANUAL DE INSTRUÇÕES
COD: 18.495
www.hinor.com.br
e-mail: [e-mail]
Toll-free
0800-478002
WARRANTY
This warranty has a term of two (2) years from the manufacturing date or one (1) year from the date of the
dealer's invoice, whichever expires first. It covers manufacturing defects that may arise during this period.
When verifying some manufacturing defect, you should take the product along with its purchasing
invoice to the store where you bought it, so that, after the dealer's analysis, your product can be either
repaired or replaced free of cost, except for any other freight expenses to the dealer store.
We do not accept complaints within the warranty term if:
a) The product has been installed without observing the INSTALLATION INSTRUCTIONS provided in
this manual;
b) The loudspeaker presents defect like torn, perforated or wet cone; installation in improper place;
distorted or smashed basket; moving coil burned due to use out of the specifications;
c) After being inspected, the product shows evidences of modifications or repairs made by unauthorized
personnel;
d) There is evidence that chemicals were used on the loudspeaker components;
e) The loudspeaker has been burned due to the use of amplifiers (power modules) not having protective
under-voltage (Battery voltage drop) circuit.
This warranty applies only to the first purchaser so that there is no conflict with the current law.
Should HINOR decide to modify the design and/or to make technical improvements on this product, it
shall not be obliged to include such changes in any product manufactured before.
The warranty offered herein covers only the repair or replacement of the product, and HINOR does not
take responsibility for any claim for indemnification of any kind.
NH INDÚSTRIA E COMÉRCIO LTDA
ROD. BR 470, km140, 5640 - VALADA
89.160-000 RIO DO SUL (SC) - BRAZIL - PHONE: [phone]
CNPJ 85776466/0001-36 - I.E.250170515
INDÚSTRIA BRASILEIRA - MADE IN BRAZIL
ITOUPAVA
INSTRUCTION MANUAL

This range of loudspeakers has been developed to reproduce low frequencies with high sound
pressure free of distortion. These are essential features when the reproduction of bass and
sub-bass frequencies is required.
Ferrite
Basket
Cone
Dust cap
Edge
Centering
Trim
Features
Details
Features Performance Graphs
The frequency response expresses the sensibility curve of the loudspeaker in all of its audible
frequency. The data shown on the following graphs was obtained in an anechoic chamber with
the help of imported dedicated software and hardware.
Frequency response
02 07
High power
- 4-inch coil with imported Copper Cladded wire y Till-sheet body;
- Vented pole and cone ring to better cool the coil;
- Bracing Neck;
- Metallic rope with silver alloy and silicone coating for higher resistance and electric
conductibility;
Optimized magnetic assembly
- Magnetic assembly optimized by means of MEF (Finite Element Method) software, providing
the moving assembly with high linearity;
- Barium ferrite of diameter 220mm and 25 mm of thickness;
- Large baskets with 210 mm of outer diameter
High linearity
- Impregnated and compacted fabrics to provide for a highly stiff centering;
- Optimized magnetic assembly with extended pole capable of assuring an even magnetic field;
- Fabric suspension capable of better responses in sub-bass and bass frequencies;
Sturdy design
- Zinc-plated Basket and poles in order to prevent oxidation;
- Polished and vanished casing ring;
- Highly stiff cast aluminum basket;
- Reflective adhesive tape;
- White color Wave Sound sewing.

93,30
4
0,431 0,470 5,211 1,291 0,0855 0,509
190,6 0,061 10,7220,38
62,39
3,3
46,63
97,12
Other details
- Use MDF or navy plywood of not less than 18 mm thick;
- Use white glue for wood in order to glue the box walls together;
- Seal all joints with a mixture of glue and sawdust;
- Use screws for MDF or plywood;
- Whenever possible, lock the box walls;
- Insulate the inside of the walls with a blanket of acrylic fiber or automotive felt;
- Weld the cable ends with tin and avoid making amendments.
The loudspeaker has been developed with a single coil for a perfect compatibility with the
different amplifier modules available in the market. The following figure shows the possible way
of connecting the coil and the resulting impedance.
Technical Specifications
Installation Details
Table 01
Technical specifications
Power rate
(Wrms)
Freq
(Hz@-10db)
Table 03
Thiele-Small parameters Fs
(Hz)
Vas
(L) Qts Qes Qms η0
(%) Sd
2
(m )
Vd
(L)
Xmax
(mm)
BL
(Tm)
Table 04
Additional parameters
Re
(Ohms)
Mms
(g) Cms
(mm/N)
Rms
(kg/s)
Vol
(L)
A
(cm)
Table 02
Loudspeaker dimensions B
(cm)
C
(cm)
D
(cm)
E
(cm)
F
(cm)
Z
(Ohms) SPL
(dB@1W/m)
SPL
(dB@2,83V/m)
2500 35-2500
8,1
4 ohms
2
CABLE = 4,0 mm
2 ohms
2
CABLE = 6,0 mm
1 ohm
2
CABLE = 8,0 mm
1 Loudspeaker 2 Loudspeakers
connected in parallel 4 Loudspeakers connected in parallel
Connection arrangements for single-coil loudspeakers
06 03
15 LINE
WARNING
*Requires the use of the REAR output of the CD/DVD player with the HPF filter
enabled for 50 Hz or higher.
15 LINE
15 LINE
15 LINE
NOTE
*The loudspeaker is supplied by the amplifier with electric power, which is
converted in sound by the vibration of its moving parts. Hinor shall not be
hold responsible for any injuries involving electric shocks produced by the
system.
95,30
499,15
2500 25-2500
18 LINE
18 LINE
0,373 0,404 5,010 2,058 0,1195 0,711131,240,41 6,0
18 LINE
235,5 0,065 11,9322,10 3,3 11,6
18 LINE
6,0
39,0
46,0
22,0
22,0
1,3
1,3
37,5
44,0
36,0
43,5
17,0
19,5

Dimensions and volume of the box
TRAPEZOIDAL BOX
EXAMPLE WITH RECTANGULAR AIR DUCT
P1
A
P2
LVol = A x L x (P1 + P2)
2000
RECTANGULAR BOX
A
L
P
EXAMPLE WITH CYLINDRICAL AIR DUCT
Vol = A x L x P
1000
NOTE: For the calculation of volume, you should use measurement units in centimeters.
Data for the Construction of Acoustic Boxes
Acoustic Boxes
For OUTWARD SOUND, use the P-length
For INWARD SOUND, use the Pmax-length
WARNING: Adjustment of the air duct length
INSTALLATION INSTRUCTIONS
*Requires the use of the REAR output of the CD/DVD player with
the HPF filter enabled for 50 Hz or higher.
1 – Select the type of air duct (rectangular or cylindrical);
2 – Select the type of box (Rectangular o trapezoidal);
3 – Adjust the length of the air duct.
All measurements recommended here are INTERNAL to generate
the total volume specified in the tables.
04 05
Woofers y sub-woofers need to be installed in acoustic boxes in order to work properly.
An acoustic box allows for the operation of a loudspeaker in optimal conditions for it to
reproduce sounds effectively and with quality, without incurring in damages due to
excess of excursion.
F3
(Hz)
G
(dB)
A
(cm)
L
(cm)
P
(cm)
P1
(cm)
P2
(cm)
Fp
(Hz)
60
75
52,0
59,0
40,0
47,0
29,0
27,5
34,0
32,5
24,0
22,5
90
90 5,6
4,0
61
60
F3
(Hz)
G
(dB)
A
(cm)
L
(cm)
P
(cm)
P1
(cm)
P2
(cm)
Fp
(Hz)
1
1
5,0
5,0 40,0
47,0 13,0
15,0
P
(cm)
QTD A
(cm)
L
(cm)
60
75
52,0
59,0
40,0
47,0
34,0
32,5
24,0
22,5
3
3
4
4
Diam
(pol)
P
(cm)
QTD
13,0
15,0
85
84
60
57
5,5
4,4
15 Line
18 Line
15 Line
18 Line
29,0
27,5
75
100
52,0
59,0
40,0
47,0
36,0
36,0
41,0
41,0
31,0
31,0
3
3
4
47,0
5,0
85
81
59
57
6,5
4,8
15 Line
18 Line
85
85 6,7
5,0
61
59
1
15,0
5,0
40,0
47,0 7,0
8,0
75
100
52,0
59,0
40,0
47,0
41,0
41,0
31,0
31,0
15 Line
18 Line
36,0
36,0
Table 06
Box with
rectangular air ducts
Table 05
Box with
cylindrical air ducts
This manual contains four (4) box projects for each loudspeaker. If you already have a box but it
has a different internal volume, please call us through our toll-free phone at 0800-47-8002, so that
we can calculate new air ducts for your box.
VT: Total box volume
A: Height of the box or the rectangular air duct
L: Width of the box or the rectangular air duct
P: Depth of the rectangular box or air duct
P1: Shortest depth of the trapezoidal box
P2: Longest depth of the trapezoidal box
Pmax: Maximum air duct depth
Qtd: Quantity of air ducts
Diam: Diameter of the cylindrical air duct
F3: Lower cut-off frequency of the box
Fp: Peak frequency of the box
G: Standard gain in the box peak performance
G
F3
Fp
0dB
-3dB
Understand the meaning of the initials given in the above tables.
Vented Boxes (Boxes with air ducts)
Good response to transients;
Frequency response adjustable by the air duct;
Good bass boost;
Low distortion in tuning frequency;
Recommended for sound tracks containing
attack bass like: Rave music, Funk, Rock,
country music...
RESPOSTA EM FREQUÊNCIA
CAIXA DIA-A-DIA
For the 15 and 18-line loudspeakers, only
vented boxes are recommended.
BOX TYPE
BOX TYPE
AIR DUCTS
AIR DUCTS
Recommended
RESPONSE
Recommended
RESPONSE
RECTANGULAR
RECTANGULAR
TRAPEZE
TRAPEZE
Recommended
Recommended