Hioth CT-LCZW5025-MH User manual

HIOTH User Manual
HIOTH TECHNOLOGY CO.,LTD.
Touch Panel Switch
Introduction
Touch Panel Switch is a wall switch with built-in Z-Wave module. It supports basic command
class, association command class, which can control all associated devices synchronously. This
product can be included and operated in any Z-Wave network with other Z-Wave certified devices
from any other manufacturers.
Technical Information
Local and remote wireless control
Touch panel and mobile control
Compatible with any Z-Wave network controller
CT-LCZW5025-MH
CT-LCZW5026-MH
CT-LCZW5027-MH
1-pole/2-pole/3-pole Touch Panel Switch

HIOTH User Manual
HIOTH TECHNOLOGY CO.,LTD.
Specifications
Radio protocol: Z-Wave
Radio Frequency: 908.42MHz
Power supply: 85 V-260V AC
Maximum load: maximum load 3 road, every road load 5A
Installation method: wall-mounted (standard American box installation)
Dimension：120mm x 75mm x 38mm
Installation Instructions
Touch Panel Switch Installation
CAUTION: Cut off power supply at circuit breaker or fuse before installation to avoid fire, shock
or death!
1) As shown in Fig.1, using the screwdriver to pry the gaps on the side of the switch, then open
the panel.
Fig.1
2) Using both hands to hold the switch panel and forcibly push up, switch panel is desirable.
3) Follow the wiring diagram to insert all wires into right terminals and tighten screws.

HIOTH User Manual
HIOTH TECHNOLOGY CO.,LTD.
Fig.2
NOTES FOR THE DIAGRAM:
L- terminal for live lead
N- terminal for neutral lead
L1-output terminal of load (controlling connected lighting device, or other load)
4) Install a switch base, as shown in Fig.3. Place the touch switch on the wall by securing the
bottom onto the junction box with two screws, and then mount the touch panel back.
Fig.3
Operation
Including of Z-Wave network:
1) Connect the power supply, and make sure that device in a state of "No node ID".
2) Press and hold any key on the panel for 8 seconds (INDICATION LED on the panel will turn
green.).
3) Choose "Z-Wave" to enter the Network Inclusion mode on the APP, then click " ".
110-220V AC

HIOTH User Manual
HIOTH TECHNOLOGY CO.,LTD.
4) If inclusion is success, switch will turn on, please go to the device list interface, and refresh
the device list, the device will be displayed.
Excluding of Z-Wave network:
1) Make sure the device is connected to the power supply.
2) Remove the device on the APP, then click "finish".
3) Press and hold any key on the panel for 8 seconds (INDICATION LED on the panel will turn
orange.).
4) If exclusion is success, switch will turn off, please go to the device list interface, and refresh
the device list, the device will not be displayed.
5) If the device can still be displayed (network exclusion failed), repeat steps 2-5.
If the device is online, directly perform steps 1-5, if the device is offline, need in-
terruption of the device power supply first, and then perform step 1-5.
Safety Notice
A qualified electrician with the understanding of wiring diagrams and knowledge of electrical
safety should complete installation following the instructions.
Before installation, please confirm the real voltage complying with the device’s specification.
Cut off any power supply to secure the safety of people and device.
During installation, protect the device from any physical damage by dropping or bumping. If
happened, please contact the supplier for maintenance.
Keep the device away from acid-base and other corrosive solids, liquids, gases, to avoid
damage.
Avoid overexertion during operation, to protect device from mechanical damage.

HIOTH User Manual
HIOTH TECHNOLOGY CO.,LTD.
Read all instructions and documentation and save for future reference.