Play contents
Host vs. Slave mode
1. Change the mode
2. Networking
4
To play a different content:
Point the remote control to the display, and press “>>” to play the
next content from the playlist.
Point the remote control to the display, and press “<<” to play the
previous content from the playlist.
The display can be set to Host mode or Slave mode. By default,
the host mode displays the content as a single device. While in the
slave mode, the display needs to be connected with another
display that is in the host mode. In such ‘networking’ setup, all
displays interconnected can be used to present a bigger display
area. The display can not be used alone, nor be controlled by a
remote control if this display is in the slave mode.
5
When the display is standby, press and hold the “setting” button on
the backplane. When the indicator light is on in red, the display is in
the host mode. When the indicator light is on in blue, the display is in
the slave mode.
To set up a ‘networking’ using multiple Hologruf displays, connect
these displays as follows:
Slave socket 2 of display #1 (in host mode) is connected to slave
socket 1 of display #2 (in slave mode). Slave socket 2 of display #2
is connected to slave socket 1 of display #3 (in slave mode), and so
on. Once this ‘networking’ setup is completed, only the display #1 in
the host mode can be controlled.
