Home HME020390N User manual

Mini Humidier
HME020390N
Thank you for purchasing our quality appliance. Please be sure to read the entirety of this user manual carefully prior to use of the product. If you have any questions regarding the use of this product, please call 1-800-898-3002.

In the event this product malfunctions or customer believes
it is defective, the customer should contact Customer Service
and retain the defective product pending further instructions.
Defective product should be clearly marked or stored where it
cannot be used again by mistake. Failure to retain the product
may impede hOme™’s ability to correct any legitimate problem
and may limit the extent to which hOme™may provide recourse.

on bringing home your new appliance!
Congratulations
Don’t forget to register your product at homelabs.com/reg
for updates, coupons, and other relevant information.
Although greatly appreciated, product registration is not
required to activate any warranty.

4
• READ AND SAVE THESE INSTRUCTIONS.
• Always disconnect the appliance before any cleaning or maintenance.
• CAUTION: Place the appliance and connected cord WELL so that the appliance is not likely to be
upset and cause re, electric shock, or injury to persons.
• CAUTION: Do not overll or clean the appliance and remove the heating element portion of the
appliance without disconnecting the power-supply cord, otherwise it may cause electric shock!
• Do not use abrasive solvent to clean any part of the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or
similarly-qualied persons in order to avoid a hazard.
• This appliance may be operated by children ages 8 and up and by people with limited physical,
sensory, or mental capacities, with or without experience, provided they are supervised or receive
instructions for using the appliance safely and that they understand the risks incurred. Children
should not play with this appliance. Cleaning and maintenance should not be performed by
unsupervised children.
• The appliance should always be placed on a rm, at, waterproof surface out of reach of patients,
children, and pets.
• Allow the appliance to cool down before assembling, dismantling, and prior to cleaning.
• Before connecting the appliance to a wall socket, ensure that the local electrical current matches
the one specied on the appliance’s nameplate.
• Do not immerse the device into water or other liquid.
• The appliance should not be left unattended in a closed room. Leave room door partly open. Do not
aim mist outlet directly at children, walls, or furniture.
• The appliance should always be unplugged and emptied when not in operation or while being
cleaned. Shut off and unplug humidier before moving. Do not move or tilt humidier while it is in
operation. Plug and unplug unit with dry hands.
• Do not operate the appliance without water. Turn off and unplug unit when water tank is empty.
• Appliance requires regular cleaning. Refer to and follow cleaning instructions.
• Do not operate outdoors. This appliance is intended for indoor residential use only.
• Do not attempt to repair or adjust any electrical or mechanical functions on this appliance. Doing
so will void your warranty.
• Do not place in direct sunlight, high-temperature areas, near computers, or sensitive electronic
equipment.
• Do not add any medications into mist outlet, base, or water tank.
Important Safety Instructions
SAVE THESE INSTRUCTIONS
For Household Use Only

5
Understanding Your Humidier
Accessories
Diffuser Pad × 5 Power Cable Filter Brush
Install the Float Pad to Control Water Flow
Float pad is a controller of water ow from water tank on ultrasonic chip. Insert the oat pad into 1 and
press securely into the slot of 2.

6
Understanding Your Humidier
Parts Overview
Top Cover
Water Tank Cover
Nozzle
Diffuser Pad
Aroma Tray
Water Tank
Handle
Mist Outlet
Water Tank
Main Body
Power Button
Touch Panel
Timer Indicator
Sleep Indicator
Spraying Indicator
Water Level Indicator
Filter
Filter Cover

7
Position the appliance
Place the Ultrasonic Humidier on an elevated surface (i.e. a table) around 23.6 in height as the below
gure shows.
11.8”
11.8”
11.8”
39.4”
Fill water
• Remove water tank cover and ll the tank with water. Make sure the water level does not exceed
the max-level line.
• After running for a period of time, remember to rell water to ensure constant operation.
Error warnings:
- If the buzzer beeps twice, the water tank is taken out from the device during operation. When
the water tank is back, the buzzer will beep twice and stop.
- Water-shortage warning: The red LED light will ash 5 times, the buzzer will beep 5 times, and
the water level indicator will show the water level.
- Full-water warning: The four white LED lights will ash 5 times, the buzzer will beep 5 times, and the
water level indicator will show the water level.
Add aroma
Take out the aroma tray, add 2-3 drops of essential oils to the diffuser pad, and insert the aroma tray back
into the unit. Install the water tank cover, the top cover of the humidier, the lter, and the lter cover.
Nozzle
Diffuser pad
Aroma tray
The convex point must be put
outward to align with the dented
point on the unit during installation.
Operating Instructions

8
Operating Instructions
Power on / off
• Connect the power cable to the back of the humidier
and then plug into a socket.
• To power on the humidier, tap the power button. The
water level indicator shows the water level. You can
start to operate the touch panel.
• To power off the humidier, tap the power button.
Adjusting mist output
If you notice water collecting around the machine, lower mist output. Tap the spraying button to cycle
among low, medium, and high speed.
• Recommended speed for different areas:
- Low speed: Under 10 m2
- Medium speed: 10–19 m2
- High speed: 20–25 m2
Set the timer
The default mode is no timer. Tap the timer button repeatedly to cycle among no timer or 2, 4, or 6 hours.
Check below gure to know which timer option you have chosen if you forget how many times you have
tapped.
No timer 2 hours 4 hours 6 hours
Sleep mode
• Tap the sleep button to access sleep mode.
• To exit sleep mode, touch the sleep button. To exit sleep mode, tap the sleep button.
Drain water
Pour out water as below gure shows.
Use a cotton swab to clean
the ultrasonic chip
Low Med High

9
Cleaning and Maintenance
• Always disconnect the device before any cleaning or maintenance.
• Drain the water out of the device.
• Place the device parts at ventilating place to dry completely.
• Clean the device regularly to ensure good performance.
• Do not wash any components of this humidier in the dishwasher.
• Do not store with water inside the base or water tank.
Replace the lter
Remove the lter grill and set aside. Pull out old lter, replace with a new one, and place the lter grill
back on top.
Handle Buckle

10
PROBLEMS SOLUTIONS
“My device is on but it’s
not producing enough
mist.”
Check to see if there is enough water in the tank. Fill with cool
water.
Make sure your device is placed on a level surface.
“My device is not
producing any mist at
all.”
The water level where the ultrasonic chip is located is too high. Take
out the water tank, pour the water out, clean the silicon inside the
water tank, and check to make sure the oat is not reversed.
If there is no red light alarm, no mist after turning on the unit,
please contact customer service as your ultrasonic chip might be
broken.
“There’s water
accumulating on the top
cover of my device.”
Refer to the “Add aroma” section and make sure your nozzle is not
on backwards.
Look at the surrounding area to make sure there is nothing blocking
the nozzle.
Make sure your diffuser pad is correctly installed by referring to the
“Add aroma” section.
Monitor your humidity levels. High-environmental humidity will
accelerate water condensation.
“There’s water on the
oor near my device.”
Look at the surrounding area to make sure there is nothing blocking
the nozzle.
Monitor your humidity levels. High-environmental humidity will
accelerate water condensation.
Make sure your device is not placed in a corner or small area on
the highest setting. For enclosed spaces without air-conditioning,
control the times to avoid excessive humidity.
“There’s water-shortage
alarm.”
Check to see if there is enough water in the tank. Fill with cool
water.
Open up your device and see if your oat is installed in the correct
direction.
If the alarm continues without cause, please contact customer
service.
Troubleshooting