Homeworx HW100STB User manual
HW100STB
)54<+8:+8(5>
:UOTY[XKZNGZZNKVXUJ[IZUVKXGZOTMGZOZYHKYZ
VRKGYKXKGJZNOY[YKX’YSGT[GRHKLUXK[YKGTJQKKVOZLUXL[Z[XKXKLKXKTIK
Sleep Setting
Notice
1
2
2
2
3
4
5
6
10
10
10
11
11
11
12
13
14
7-9
10-12
1
This marking consists of two graphical symbols and a warning message. The detailed
specifications are as follows:
To reduce the risk of electric shock, do not remove the cover. Equipment service and
maintenance should only be undertaken by trained personnel.
When not in use for an extended period of time, unplug the power cord from the outlet. Additionally, do not use a damaged power cord.
Do not touch the power cord with wet hands. If there is liquid flowing into the unit, pull out the power cord immediately as it may cause
a fire or electric shock.
Place the unit in a well ventilated area away from heat sources.
2
3
Press to mute the sound of TV audio. Press it
again to restore the sound
Press to turn closed captioning on or off
Make sure the STB is connected properly as below:
4
Connect the RF OUT to another TV if necessary.
5
Refer to your television user's manual if necessary.
6
Special Notice
Parental Control
Default password is: 0000.
7
Special Notice
8
RRT Settings
OK
Confirm the password. If successful, you wil
get the message shown in
Special Notice
9
8
9
10
10
Press PROG key when the TV is showing
no menu to bring up the channels list (Figure
8). Information about channel numbers,
name and skip status of all channels are
shown here.
Press EPG key to open the EPG window.
It wil display the first page of the program
scheduler.
11
1
1
11
(The numbers indicate the sleep timer in hours.)
1
1
12
NOTE: When under the setting of LOOP THROUGH, the machine will not play the TV program. Antenna
television broadcasting signals will be directly output through the RF OUT terminals. If output
signal isn’t very good in standby, please turn off the power switch of set-top-boxes.
13
14
Table of contents
