*When pouring water into the water tank, the Filter Basket must be fit on
the water tank to prevent the coffee powder or other dust from falling into
the water tank.
3. Put a Capsule into the Capsule Chamber (step 2-3)
4. Close the Lid Assembly and turn the Locker knob to Locker position (step4-6) and press it
down by your hand.
5 Place a cup on the Drip Tray Cover. Please make sure that the middle of the Cup is under
the Coffee Outlet. (step 4-6)
*Remove Drip Tray to adjust the height of the cup table (please see the pic.1)
Or place the opposite side of the Drip Tray Cover on the Drip Tray to adjust the height
of the cup table (please see the pic.2)
6. Plug into the 120V power supply and press the power button to turn on the machine.
At the beginning, the boiler is heating up, the indicator light keeps flashing at the same time,
after heating, the water is pumped and the light will be on until the end of brewing.
7. The machine turns off automatically after brewing.
8. You can stop brewing at any time if you wish, and then if you need to continue to brewing,
you can press the power button to work once again, but if the indicator light keeps flashing fast,
it means the system temperature of the machine is too hot, you have to wait for at least 1
minutes or you can pour some cold water into water tank, then start the machine again.
9. Please use water to clean the water tank for the first use or for use after a long period of
time.
Caution: During normal working, don't allow to open the Lid Assembly.
CARE AND CLEANING
To clean the outside of the brewer:
1. Unplug the machine and let it cool down before cleaning.
2. Use a clean damp cloth to clean all outside surfaces. Do not use harsh abrasives to clean.
3. When cleaning the Capsule Chamber, you can take out and rinse the coffee outlet
periodically, place cup on the Drip tray Cover, and then pour some pure water to the Capsule
Chamber to clean it.
* Please pay attention to the stainless steel Piercing tip on the bottom of
the K-cup® Holder and a sharp Plastic Piercing tip that punctures the
K-cup® on the underneath side of the lid assembly, to avoid risk of injury.
4. Remove drip tray from the machine, and lift drip tray cover off the drip tray. Wash all pieces
with soap and water.
5. Take out the Filter Basket from the water tank to clean it, in parallel please pour pure water
(no more than 360CC) into the water tank and shake the machine several times to clean it, and
then pour off the water from the water tank. (please see the pic.3)
To descale the inside of the brewer Unit:
1. Fill the water tank with 12OZ water with household scale remover (ratio 4:1);you can also
use citric acid with 3% ratio instead of professional scale remover, which can be bought in a
lab or pharmacy, then close the lid assembly, place the coffee cup on the drip tray, and press
