HONU HAWAII User manual

OPENING
To open the bladder, slide the red tab on the
bladder cu outward, then pull up to remove
the sealing cu. The cu hinges like a door
and slides o at a diagonal,
as pictured.
FILLING
Unfold the bladder seal at the top of the
bladder. Fill with cool water to the
‘optimum ll line.’
COOLING
Insert ice or frozen gel packs as desired. Check that the water level does not rise
higher the ‘do not exceed’ line.
LOADING
Close the bladder seal ap and then put the sealing cu diagonally on to the bladder. The cu hinges on to the
bladder like a door, as pictured. Slide the red tab back into a locked position. Please the cued bladder into the HONU
pouch with the tube connectors facing outward.
CONNECTING
Click the two Quick Connector tube attachments into place on the bladder tube
connection points, as pictured. Be sure that the Quick Connector tabs are in an
open position – you will hear a click as the connectors lock into place.
POWER
Connect the USB line from the bladder to the battery pack and turn the switch ‘on.’ Check that pump is running by
monitoring water ow through clear tubing – water should circulate within 15 seconds. Flip the switch to ‘o’ to stop
the pump.
TROUBLESHOOTING FLOW
If water doesn’t ow through the ThermoCore system, turn o the unit and double check the tube-bladder connections.
Check that the liquid level inside the bladder is higher than the optimum ll line and that the pump is completely
submerged. through clear tubing – water should circulate within 15 seconds. Flip the switch to ‘o’ to stop the pump.
1
2
3
4
5
6
7
INSTRUCTIONS
FOR USE

CARE INSTRUCTIONS
1. Spot clean with a damp cloth.
2. For complete cleaning, dunk HONUin soapy water, and rinse in cold water.
3. Air dry. DO NOT WRING OUT.
STORAGE
1. When not in use for an extended time, we recommend to drain all water from HONU tubes.
2. To drain water, empty the bladder and then click open the Quick Connector
tabs at the ends of the HONU tubing and let drain.
3. Store in a dry place.
PRODUCT
CARE