Hoops Pro Dunk® Original Select & Premium
Assembly Instructions
www.HoopsDallas.com 866-944-6677 Page 2
NOTE: Immediately unpack all components and cross check against bill of materials. Report any shortages to
Hoops customer service at 1-866-944-6677.
Instructions
1. Locate and dig a 12" minimum diameter x 36" deep hole.
2. Fill hole with wet premixed concrete, insert vertical pole leaving 108" above desired playing surface. Vibrate to settle
concrete. Place 4" square post cap on top of pole.
3. Make sure post is straight and plumb. Brace while drying if necessary. Allow 24 hours minimum drying time before
continuing assembly.
4. Using 4"x ½" U-Bolts, lock washers and nuts attach the extension arm to the vertical pole either at the desired rim
height or at ground level.
5. Loosely attach backboard braces to extension arm using 2"x 3/8" U-Bolt, clampbar, flat washers, lock washers and
nuts.
6. Remove and discard the shipping block (plastic piece) located at the backboard joint. Bolt on backboard frame support
to the center four holes located at the top of your backboard using the 5/16" hardware provided with the backboard.
7. Attach desired backboard and rim placing bolts through rim, backboard and extension arm. Tighten with rim level to
backboard and arm. Packaged in with your backboard are two black rubber gaskets. Be sure to place one rubber gasket
between the face of the backboard and the rim and the other between the extension arm and the backside of the
backboard. Trim gaskets if necessary.
8. Attach backboard braces to side holes in backboard frame using 5/16" hardware provided. Bend braces to fit as
necessary.
9. Tighten all bolts.
10. If you attached extension arm at ground level, slide entire assembly to desired rim height and tighten U-Bolts making
sure entire project is level and square. When sliding assembly, be careful not to scratch the paint on the vertical pole.
Tip: If you are setting the unit at 10 feet, the bottom of the extension arm will be bolted approximately 95 ½" up
the vertical post.
