Horizon Fireplaces Kemlan 700 User manual

----FIREPLACES----
Installation Instructions
Horizon Portrait Power Flue Gas Fireplaces
7/8/2017 Ver. 1

3
T=flue terminal
I =Mechanical air inletM=Gas meter
P = Electricity meter or
fuse box
Shading indicates
prohibited
areas for flueterminals
aBelow eaves, balconiesor other projections:
Appliances upto50 MJ/h input
Appliances over 50 MJ/hinput
From the ground or above a balcony
From a return wall orexternal corner
From agasmeter (M)
From anelectricity meter or fusebox (P)
From a drain orsoil pipe
Horizontally fromany building structure (unless applianceapproved for closer
installation) or obstruction facingaterminal
Fromany other flueterminal, cowl,orcombustion air intake
Horizontally from anopenable window, door, non-mechanical air
inlet, or any other opening into abuilding, with theexception of
sub-floor ventilation:
Appliances upto150 MJ/h input
Appliances over 150MJ/h input
From amechanical air inlet, including a spa blower
MIN. CLEARANCE
(mm)
300
500
300
500
1000
500
150
g500
500
h
j
500
150
150
k
nVerticallybelow an openable window, non-mechanical air inlet
orany otheropening into a building,with theexception of
sub-floor ventilation See table below
NOTES:I. All distancesare measured vertically or horizontally alongthewall to apoint
in line with the nearest partoftheterminal.
2. Prohibited areabelow electricity meter or fuse boxextends toground level.
3. Seeclause 5.13.6.6 for restrictions onaflueterminal under aroofed area.
4. SeeAppendixJ, Figure JI (a) and J2(a)forclearances required from a flue
terminal to aLPGas cylinder. Aflue terminal is considered tobe a source ofignition.
MINIMUM CLEARANCES REQUIRED FOR BALANCED FLUE TERMINALS
OR THE FLUE TERMINALS OF OUTDOOR APPLIANCES
CLEARANCES'n' (mm)
Space heatersAll other appliances
Upto50
MJ/h
Input
UPto 50 MJ/h
inputOver 50 MJ/h&up
to 150 MJ/h Over 150 MJ/h
input
150 500 10001500
b
c
d
e
f
7/8/2017 Ver. 1
Installation Instructions Kemlan Portrait Power Flue Horizon Gas Fireplaces

Installation Instructions Kemlan Portrait Power Flue Horizon Gas Fireplaces
7/8/2017 Ver. 1 5
E
C+
B
C+
* TO UNDERSIDE OF FLUE WITH EXTERNAL FAN (1300mm)
** TO UNDERSIDE OF FLUE WITH INTERNAL FAN (1010mm)
+ OUTER BOX SIZE ONLY, NOT INCLUDING LIP FRAME
Power Flue
EXTERNAL FAN
CASING
3 PIN PLUG 240
VOLT 10 AMP
ISOLATING SWITCH
3 PIN PLUG 240 VOLT
10 AMP ISOLATING
SWITCH
ON/OFF SWITCH
TO BURNER
A
D
INTERNAL FAN
SINGLE SIDED-REAR EXIT
EXTERNAL FAN
SINGLE SIDED-SIDE EXIT
ON/OFF SWITCH
TO BURNER
GAS INLET
CONNECTION UNDER
BURNER TYP.
ELECTRICAL LOOM
CONNECTOR BURNER
TO FAN
ELECTRICAL LOOM
CONNECTOR BURNER
TO FAN
REMOVABLE GAS
BURNER PEBBLE/COAL
OR LOG
AGA APPROVED
GAS COWL
INTERNAL FAN
CASING
F
J
SPIGGOT TYP. DETAIL
G
SINGLE SIDED A B C+ D E F G H I J
700 PORTRAIT 700 600 365 1087 1000 178 225 10 15
*/**
850 PORTRAIT 850 600 405 1182 1095 225 275 10 15
*/**
10MM
SHEETING
HI
LIP FRAME DETAIL
TYP.
FRONT OF
FIREPLACE
LIP TRIM
D
J
B
E
A
GAS INLET
CONNECTION UNDER
BURNER TYP.
REMOVABLE GAS
BURNER PEBBLE/COAL
OR LOG

Power Flue with Internal Fan
HEAT TRANSFER
BOX
SILENCER
8” x 900
REDUCER
7” –6”
8” –6”
9” –6”
10” –6”
12” –6”
14”-- 6”
GAS COWL
COOLING ROTOR
INBUILT THERMAL
OVERLOAD
COOLING IMPELLER
6” x 900
12.5” x 900
12.5” x 200 VENTED FLUE
Note:
Power flue Horizontal runs greater than 5 meters in length may be compromised by
fluctuations in power. Flue runs greater than 5 meters when tested with underload power
of 15% caused the fan to cut out and burner to turn off and require resetting.
Resetting can be done by turning power off and on. Should power be consistent in supply
then longer flue runs can be recommended and burner will perform correctly.
7/8/2017 Ver. 1
6
Installation Instructions Kemlan Portrait Power Flue Horizon Gas Fireplaces

Power Flue with External Fan
SILENCER
8” x 900
REDUCER
7” –6”
8” –6”
9” –6”
10” –6”
12” –6”
14 ”-- 6”
WALL MOUNTED
FAN
2x 8” 45 DEG
12” –8”
REDUCING CAP
6” x 900
12.5” x 900
2x 6” 45 DEG
12.5” x 200 VENTED FLUE
10MM GAP BETWEEN
END OF FLUE TO WALL
Note:
Power flue Horizontal runs greater than 5 meters in length may be compromised by
fluctuations in power. Flue runs greater than 5 meters when tested with underload power
of 15% caused the fan to cut out and burner to turn off and require resetting.
Resetting can be done by turning power off and on. Should power be consistent in supply
then longer flue runs can be recommended and burner will perform correctly.
7/8/2017 Ver. 1
7
Installation Instructions Kemlan Portrait Power Flue Horizon Gas Fireplaces

8
Installation Instructions Kemlan Power Flue Horizon Gas Fireplaces
7/8/2017 Ver. 1
FRAMING DIMENSIONS
SINGLE SIDED
C
B
A
C* INCLUDING 10mm PLASTERBOARD
SINGLE SIDED A B C C*
700 PORTRAIT 1056 1197 370 390
850 PORTRAIT 1145 1292 410 430

7/8/2017
Ver. 1
300 MIN. TO VERTICAL
SURFACE (CEILING)
110 MM MIN.
FAN ( 300MM x 105MM )
137 MM.
OPTIONAL SECOND
FAN
TIMBER SUPPORT
REQUIRED
SPIRAL DUCT 150MM MAX.
- WITH NO AIR POCKETS
- CANNOT BE VENTED
UNDERNEATH UNIT
INSULATION BOARD
SECTION A-A
HEATZONE
ACTIVE FLUE
CASING
FULL WELD
HEAT ZONE CONVERSION
9
Installation Instructions Kemlan Portrait Power Flue Horizon Gas Fireplaces

10
7/8/2017 Ver. 1
AGA APPROVED
GAS COWL
APPROVED
FLASHING
SECTIONS
25MM MIN. FLUE
CLEARANCE TO
TIMBER
HORIZON GAS
FIREPLACE
10MM COMPRESSED FIBRE
CEMENT SHEET BETWEEN
UNIT AND BOTTOM SUPPORT
FRAMING
FRAMEWORK
AND 10MM WALL
LINING BY
INSTALLER
150MM MIN .
110MM MIN .
Installation Instructions Kemlan Portrait Power Flue Horizon Gas Fireplaces