2- Side Frames 2- Wine Racks 4- Feet1 Tray 4- Levelers 24- Screws
1. Attach one of the wine racks to one of the side frames.
Note: A Phillips screwdriver is required for assembly.
Parts List:
MODEL 655147
ASSEMBLY INSTRUCTIONS
2. Attach the second wine rackto the side frame as
in step 1.
4. Attach the feet to the bottom of the stand and insert
the levelers into the feet.
Hole
Faces
In
The studs on the wine
rack must be inserted
ino the holes in the side
frame.
The holes in the
bottom of the wine
rack and in the
bottom of the side
frame should be
aligned as shown.
3. Lay the second side frame down on a clean non-abrasive
surface. Insert the studs on the wine racks into the holes in
the side frame and attach the racks to the side frame as in
step 1.
5. Turn the stand upright and adjust the levelers so that
the stand sits level on the floor and does not rock.
Place the tray on top of the stand.
©Copyright Howard Miller Clock Company PD12365
10/08
When placing the tray on top of the
stand, the metal studs on top of the
stand must be inserted into the holes
in the bottom of the tray so that the
tray does not slide off the stand.
Note:
