HPE AP-303H-MNTD User manual

AP-303H-MNTD Desk Mount Kit
Installation Guide
0511971-02 | February 2017 1
Package Contents
Mount stand
Mount cover
M2.5x7, T8 Hex screws
(x2) M2.5x12, T8 Hex screw
RJ45 Ethernet jumper
 AP-303H-MNTD Desk Mount Kit Installation Guide
Introduction
The AP-303H-MNTD Desk Mount Kit is a stand-alone mount for the 303H access point. This kit is equipped with
an Ethernet cable which may be used to link the E0 and PT ports on the back of the access point to enable uplink
capability from the E0 port located on the bottom of this device.
Mount Kit Assembly
1. Insert the mount cover into the mount stand, then insert the M2.5x7, T8 Hex screw into the hole located on
the bottom of the stand and screw both pieces together (Figure 1).
Figure 1 Attaching mount cover to stand
2. Link the E0 and PT ports on the back of the access point using the RJ45 Ethernet cable.
AP-303H-MNTD.fm Page 1 Monday, February 27, 2017 2:49 PM

© Copyright 2017 Hewlett Packard Enterprise Development LP
0511971-02 AP-303H-MNTD Desk Mount Kit | Installation Guide
Figure 2 Securing the access point to the mount cover
3. Align the slots on the back of the access point to the corresponding posts on the inside of the mount cover
(Figure 2). Press the access point into the cover, then pull down on the device until the posts engage with the
slots. When properly attached, the device should be positioned flat against the cover.
4. Insert the two M2.5x12, T8 Hex security screws into the holes on the back of the mount stand and tighten to
anchor the access point to the mount (Figure 3).
Figure 3 Anchoring the access point into the mount
5. (Optional) Use the Kensington lock slot located on the back of the mount stand to lock this mount kit to a
secure surface.
E0
57V 600mA
PT
AP-303H-MNTD.fm Page 2 Monday, February 27, 2017 2:49 PM