HPE AP-505H-MNT2 User manual

AP-505H-MNT2 Mount Kit
Installation Guide
0512198-01 | May 2020 1
The AP-505H-MNT2 is designed to secure 505H Series access points to a dual-gang wall box according to the
installation procedure provided in this guide.
Package Contents
Double gang wall mount bracket
Side cover
(x4) #6-32x1 Phillips drive screws
(x2) M2.5 x 6.5 T8H Security Type Tamper Proof Torx screw
Installation
1. If the wall box is not already exposed, unscrew and remove the existing wall plate, as shown in Figure 1.
Figure 1 Remove Existing Wall Plate
2. If needed, detach any RJ45 cables by unclipping the connectors from the wall plate.
3. Align the screw holes on the mounting bracket with the corresponding holes on the wall box.
A #1 Phillips and T8H screwdriver are required for installation.
This mount kit supports dual gang wall boxes for the 505H Series access points.

2AP-505H-MNT2 Mount Kit | Installation Guide
4. Screw the wall mount onto the wall box using the #6-32x1 Phillip screws, as shown in Figure 2.
5. Attach an active Ethernet cable to the E0 port located on the back of the access point.
Figure 2 Attach Wall Mount to Single Gang Wall Box
6. Align the slots on the back of the access point against the guide posts and slots on the mount, then slide the
access point down, as shown in Figure 3.
Figure 3 Secure AP-505H to Wall Mount
7. (Optional) If the access point requires a DC power adapter, insert a power cable into the socket located on
the side of the access point, as shown in Figure 4.

AP-505H-MNT2 Mount Kit | Installation Guide 3
Figure 4 Plug In Power Cable
8. Place side cover on the assemble and screw in the security screw, as shown in Figure 5.
Figure 5 Attach Front Cover and Screw In Security Screw
1
2