HSC Elite T5000 User manual

T5000 (MB50) OPERATING INSTRUCTIONS
PLEASE ENSURE YOU HAVE READ AND UNDERSTOOD THESE INSTRUCTIONS FULLY, BEFORE ATTEMPTING TO OPERATE
THIS EQUIPMENT
GENERAL SAFETY
Never place anything on top of the unit and never obstruct its air inlet/outlet grills. Leave a 300mm gap all around the
unit to let the air circulate. ALWAYS switch OFF unit and unplug when not in use
ELECTRICAL SAFETY
This fan unit plugs into either a standard 240v 13amp or a 11v power supply, depending on the model (see Data plate or
the voltage type). The plug (240V MODELS ONLY) is fitted with a 13amp fuse.
DO NOT FLASH TEST ABOVE 1250V. PERMANENT DAMAGE WILL OCCUR
Extension leads should be: correctly rated for the inductive load, fully unwound, loosely coiled and never run through
water or over sharp edges
To reduce the risk of electric shock use a suitable RCD (residual current device). NEVER pull the equipment by its flex.
SET UP & OPERATION
Set the unit up on a firm, level surface and do not site the unit close to any personnel wearing contact lenses, sensitive
to any dust movement, hay-fever sufferers etc. This unit moves air only, but minute particles of dust/pollen etc. will also
be moved, especially on the highest fan setting, so careful location/fan angle/use of speed control will require
consideration.
The body of the fan is held in position via the side mounted hand-wheels. To adjust, slacken the wheels to allow the fan
body to be move. Once the desired angle is reached, ensure the hand-wheels are turned hand tight to prevent
movement
The air-flow from the fan exits from the side with the speed controller on it (the front), the intake side is opposite
Plug the unit into the relevant power supply and switch ON.
Press the red ‘rocker’ switch, on the front of the unit to ON, which will then illuminate. ALWAYS START THE FAN ON THE
HIGHEST SPEED SETTING. The fan blade should immediately start to turn & the speed can be controlled with the knob on
the control panel, turning CLOCKWISE TO INCREASE, ANTI-CLOCKWISE TO DECREASE. Do not force the knob past the
stop point, you will damaged the speed controller.

EQUIPMENT CARE & STORAGE
NEVER use an air mover except for its intended purpose.
Keep the equipment clean & especially the grill faces. Blow out the grills with the compressed air if ‘clogged’ up.
NEVER MOVE THE UNIT WHILST OPERATING
Switch the unit OFF and unplug from its power supply, wrap the cable round the storage ears.
TROUBLESHOOTING GUIDE
PROBLEM
LIKELY CAUSE
SOLUTION
UNIT FAILS TO OPERATE
POWER FAILURE
CHECK UNIT IS PLUGGED IN TO
THE POWER SUPPLY
CHECK PLUG FUSE (240v ONLY)
FOR FAILURE & CORRECT
13AMP RATING
CHECK SPEED CONTROLLER
FUSE LOCATED AT REAR OF
CIRCUIT BOARD
110V MODELS CHECK POWER
SUPPLY IS SUITABLE FOR THE
INDUCTIVE LOAD
CHECK BUILDING RING CIRCUIT
IS NOT OVERLOADED
POOR AIRFLOW
SPEED CONTROL ON LOW
SETTING
GRILLS DIRTY
AIR INLET GRILLS OBSTRUCTED
TURN SPEED CONTROL KNOB
CLOCKWISE TO INCREASE
AIRFLOW
BLOW COMPRESSED AIR
THROUGH GRILLS TO CLEAN
REMOVE OBSTRUCTION
The Hire Supply Company (UK) Ltd
Building 7-10 Eldon Road Trading Estate, Attenborough, Nottingham, NG9 6DZ, UK
[phone] Email:[e-mail]