TYPHOON USER MANUAL
GENERAL SAFETY INFORMATION
DO NOT position the cooler up against the wall and position near any other structure that may restrict the
air ow around the unit. Ensure a 1-meter gap is observed around the unit when in use.
Always ensure there is sufcient air ow around the front and back
When not in use always remove the unit from the power supply.
When removing the plug from the socket always do so by holding and pulling the main body of the plug
and NOT the cable.
DO NOT modify this equipment to do tasks other than those intended, this will invalidate your warranty,
product approvals and pose a risk to the user, bystanders, and property.
DO NOT use in in an enclosed environment. There must be sufcient air ow for the unit to function
correctly and perform to its full capabilities.
Never leave the unit running unattended.
DO NOT use the equipment if there is any damage noted on the mains inlet cable.
Ensure the mains cable does not present a trip hazard.
DO NOT run the main cable across walkways, paths or in front of doors / doorways. Once the cable
has been routed into the desire position please secure. Also consider and avoid sharp edges, water and
chemicals when positioning the cable.
Ensure the cable is fully unwound before use.
If the external mains cable is damaged, it shall be exclusively replaced by the manufacturer or his service
agent or a similar qualied person in order to avoid hazard.
In some applications it may be necessary to complete a risk assessment and method statement on the use
of this product. Please note this is the responsibility of the user to consider all foreseen and unforeseen
risks and mitigate where possible.
Reading, understanding and adhering to these user instructions is essential for safe use and sufcient
product training.
CAUTION
DO NOT use the equipment if there are any signs of damage that may present a hazard in use. If you are
unsure seek advice from a qualied person, retailer, or the manufacturer.
It is recommended this unit is used with an RCD device.
Ensure your hands are dry when connecting, using, and disconnecting and electrical appliance.
Always make sure the plug fuse and any other circuit protection is of the correct rating, refer to the
products rating label. If you are unsure, please contact either the reseller or manufacturer for assistance.
