IAdea PTM-101 User manual

PTM-101 Tilt Wall Mount
Quick Start Guide
This printed quick guide provides a quick walkthrough of the set up process.
Technical Spec
Net weight 0.4 kg
(0.88 lbs)
Dimension
(W * H * D)
116 mm x 116 mm x 66 mm
(4.56" x 4.56" x 2.59")
Screw type M4
Material Steel
Hinge module Tilt
Torque adjustment
-5° ~ 20° (free angle)
Available
Display support
Mounting pattern
Panel size support
Support weight
100 mm x 100 mm / 75 mm x 75 mm / 50 mm x 50 mm
< 28"
15 kg (33.06 lbs)
Distance to wall 66 mm
(2.59")
Safety lock N/A
Anti-theft lock N/A
Box Content
Item Parts Q'ty
1 Wall Bracket 1
2 Fixed Plate 1
3 Washer ( 1/4") 2
4 Spring Washer ( 1/4") 2
5 Screw (RH 1/4" - 2 UNC * L 5/8") 2
6 Screw for monitor (M4 * P0.7 * L 12mm) 4

1 Mount the Wall Bracket (1) on to the wall.
- for wooden structure, self-tapping screws are recommended.
- for brick structure, use 7.5 mm drill bit to open a 50 mm depth hole to hammer in wall anchors, then
install screws. Self-tapping screws are recommended.
Mounting and Installation
2 Install Screw for monitor (6) into the Fixed Plate (2) to lock the the mount screw-holes located at the
back of the digital signage.
3 Hook the bar on the back of the Fixed Plate (2) on to bar holder at the top of the Wall Bracket (1).
4 Place one of the Screws (5) through a Spring Washer (4), a Washer (3), and then insert it through the
hole on one side of the Wall Bracket (1), with Fixed Plate (2) hooked.
5 Repeat step 4 to complete installing the other side of the Wall Bracket (1), with Fixed Plate (2) hooked.
6 Adjust the tilt of the Fixed Plate (2) to the angle desired and then fasten the Screws (5) on both sides of
the Wall Bracket (1), with Fixed Plate (2) hooked, to complete the PTM-101 mounting installation.
Product Photos
PTM-101 intalled
Hooking Fixed Plate (2) to
Wall Bracket (1)
Screws (5) through a Spring
Washer (4), a Washer (3)
Digital signage tilted upwards
Digital signage tilted downwards