ICON 16A92 Parts list manual

Field Replacement Guide for iCON™
Local Display (16A92)
507705-01, 7/2018
Supersedes 6/2017
WARNING
Improper installation, adjustment, alteration,
service or maintenance can cause property
damage, personal injury or loss of life.
Installation and service must be performed
by a licensed professional HVAC installer
(or equivalent) or a service agency.
Removing Existing Touchscreen
1. Disconnect power to the entire system.
2. To remove the iCON Local Display
from Mag-Mount base rotate in either
direction the touchscreen 30 degrees and
pull away from wall to remove. Failure
to rotate display before pulling off
requires much more force to be used
and may pull out wall anchors.
3. Discard original iCON touchscreen.

2
Installing New Local Display
1. Line up iCON Local Display with Mag-
Mount base.
2. Insert bottom of the iCON Local Display
at 30 degree angle into tabs at bottom of
the Mag-Mount wall base.
3. Rotate the iCON Local Display upward
until it snaps into place by pressing on
sides.
4. Use the through-hole screw previously
removed to secure the iCON Central
Hub.
5. Do not remove the label covering the
touchscreen until after power is applied
to the system.
6. Restore power to system.
7. Remove label covering the touchscreen