TPD-283-H/283U-H Quick Start, version 1.0 Last Revised: April 2017 - 3 -
Copyrigh
t
©
2017
ICP
DAS
Co.,
Ltd.
All Rights Reserved. E-mail: serv[email protected]om
The definition of the rotary switch (TPD-283U-H):
This is a special run mode which is used in the
development stage. The TouchPAD device can be
updated by a PC from the remote side through
Ethernet.
While the application run on the TouchPAD device
seriously crashes, use this mode to update a new
application to the TouchPAD device through Ethernet.
Update a new application to the TouchPAD device
through USB.
4First Use of the TPD 2.8”H Series
1. Connect wires as the figure or prepare an Ethernet cable
which will be used to supply power through PoE if there’s a
RJ-45 Ethernet port on it. And set the rotary switch to zero
(At this point, the power is not yet supplied).
2. Supply power to the TPD-283-H/283U-H, wait for several seconds and
then you can see the default program run on it.
3. Try to touch on the icons on the bottom-right corner of the screen of
the TPD-283-H/283U-H and you can find that TPD-283-H/283U-H
switches to the setting pages.
Use a flat-head screwdriver to set
rotary switch
