Illustra IFBMNTBOX User manual

Junction Box
Quick Start Guide
Illustra Flex 3MP Outdoor Bullet Camera
8200-1454-01 B0

2
Product overview
The Junction Box, IFBMNTBOX, is compatible with the Illustra Flex 3MP Outdoor camera IFS03BIBNWIT.
Table 1 provides the product code and description of the camera.
Use the Junction Box kit to mount the camera on a ceiling or wall surface.
Product code Description
IFS03B1BNWIT Illustra Flex 3MP Bullet, 2.8-12mm, outdoor, non-vandal,
white, TDN w/IR
Table 1. Product information of junction box camera compatibility
Figure 1. Physical dimensions (mm)

3
Installation and mounting
Check everything in the box matches the order form and packing slip.
Contact your dealer if any item is missing.
The box contains the following items:
•One junction box IFBMNTBOX
•One Quick Start Guide 8200-1454-01 A0
•One waterproof rubber sealing gasket
•Six security torx screws
•Six plastic anchors and screws (TP4)
Required tools
The following tools assist with installation:
•A drill
•A hammer
•A Phillips head screw driver
•Wire cutters
Installation and mounting procedure
To install and mount the camera, complete the following steps:
1 Drill 6 holes on the wall or surface, based on the mounting template.
2 Hammer the 6 screw anchors into the drilled holes.
3 Fix the junction box onto the wall or surface by fastening the 6 TP4 Tapping screws with the 6
screw anchors
Figure 2. Fixing the Junction Box
4. Pass the cable thread of the camera through the adapter plate, and then secure the camera with the
adapter plate by fastening the 4 T20 screws.

4
Figure 3. Securing the camera to the adaptor plate
5. From the rear side, cover the cable thread with the waterproof rubber sealing and fasten them to
the holding bracket plate using 3 T20 screws fixed onto the exact place.
Figure 4. Threading the cables
6. Place the cable thread inside the junction box to connect with the required cables penetrating from
either the bottom or side conduit hole, and assemble the junction box with the adaptor plate by
fastening the 3 T20 screws.

5
Figure 5. Assembling the Junction Box with the adaptor plate
You have completed the installation of the camera on a wall or surface, as displayed in Figure 6
below.
Figure 6. Final mounting
Notes and warnings
•It is advised to apply rubber tape splicing tape around the required cables, which are slated for
passing through either the bottom or side conduit hole, for securing waterproof function.

6
Mounting Template
The Junction Box, IFBMNTBOX, mounting template is below. Use this template to locate where to drill
the holes for the mounting and installation of the camera. The height by width of the template below is
136 mm x 136 mm.
Figure 7. Mounting template (mm)
IFBMNTBOX, Junction Box Mounting Template