imec IE 93 User manual

USER MANUAL
IMEC IE 93 HAND DRYER
Code: 300-1193
Please read user manual carefull before using.

Characteristic
1) Touch free,just put hands below the wind spout within 15
cm.
2) To avoid power wasting due to continuous error
induction by objects in the detection zone, it has been
set with the function of power on over 0.5 second and
power off automatically over 1 minute.
3) Design with 105 centigrade thermal cut off.
4) Drying time is 35-40 seconds.
5) High R.P.M. with low noise and dry hand quickly.
6)Easy to mount and install. Instruction included.
7) Curvaceous, smooth and elegant.
Installation
1) The machine should be fixed on the firm and fastened wall.
2) Do not install the dryer on the wall which raw material is
flammable.
3) Do not jam the wind mouth.
4) Please cut off the power immediately when the dryer occurs
breakdown and please try to contact the seller for more
information.
5) Forbid to wipe the outer shell with caustic liquid, such as
banana water and alcohol.
6) Do not dismantle the dryer except by a
professional.
7) Avoid the dangerous situation which can damage the cord.
The power cord should be repaired by the maintenance team
of manufacturer or similar agency’s careerman.

Installation Diagram

Notice
Drill four holes on the wall as diagram 1. Then insert expansion
tube into the hole. Fix the hook on the wall by enclosed
spareparts hang the hand dryer on the hook by the fitting
hardware on the back of the hand dryer. Push the hand dryer
from up to down until it is tight as diagram 2. Connect the
powerplug to the electrical power.
Power Diagram
Technical Data
Voltage AC 220V / 50Hz
Rated Power 1500 W
Sensor Range 50~150 mm
Air Temperature > 40oC (Envir. 25oC)