Imperial Westbury 1 Drawer User manual

INSTRUCT185
REV060717 A JRS
Installation instructions for Radcliffe Westbury wall hung units
Important Information:
Please check the products for transport damage and that contents are complete
before installation.
Consult a qualified plumber if you have any problems installing this product.
Complaints made following installation regarding the above cannot be accepted.

2 of 8
Thank you for purchasing this Imperial product. Please take a moment to
review this manual before you install your product. If you encounter any
installation or performance problems, please do not hesitate to contact us
using the phone number listed on the back cover of the booklet.
Upon receiving your product please open all cartons carefully and inspect for
any manufacturing defects or transit damage.
Imperial cannot be held responsible for damaged products after or during
their installation.
This installation guide and the fixings provided are intended for fixing into
solid walls. If you are installing this product into a stud wall structure or any
other type of non solid wall please amend your installation techniques and
fixings accordingly.
Ensure that you have a clear space within which to work.
Imperial recommend the guidance of a qualified plumber in the
installation process.
Always observe the plumbing and building regulations in the area the
product is being installed in.
General Instructions
Tools Required
drill screwdriver spirit level pencil spanner silicon
Westbury 1 Drawer Wall Hung Unit Westbury Open Wall Hung Unit

3 of 8
Wall-hung vanity units
Screw Hole Dimensions
Prior to drilling check for hidden cables & pipes
• Prior to installation ensure all necessary pipework and plumbing is carried out.
• Check wall for level.
• Measure the distances between hole centres along the rear top rail of the unit.
Using these measurements, mark up the wall where holes will need to be drilled -
taking care to position the unit so that fixings will secure into brick and not mortar
(this is crucial to ensure a solid and secure installation).
• Drill all necessary holes and insert wall plugs.
• Screws and wall plugs supplied with unit.
90
60
560
60 152 143 141 63
45
250 400

4 of 8
Waste (Wall) Outlet Position
Trad Bottle
Trap
Modern Bottle
Trap
Standard Waste Pop-Up Waste
40mm MIN
82mm MAX
40mm MIN
72mm MAX
40mm MIN
67mm MAX
40mm MIN
57mm MAX
Measurements taken
from centre of waste outlet on
the trap to inside floor
of unit.
Trad Bottle Trap + Standard Waste
Modern Bottle Trap + Standard Waste
Trad Bottle Trap + Pop-Up Waste
Modern Bottle Trap + Pop-Up Waste
40mm
40mm
40mm
40mm
82mm 67mm
72mm 57mm

5 of 8
fig. A
Prior to drilling check for hidden cables & pipes
• Support the unit from underneath and offer it up to the wall. Secure all fixings
through the unit and into the wall, ensuring all connections are tight and firm.
• Secure Basin to unit with a small bead of silicon sealant to finish. (fig A)
• You are now free to connect all plumbing fixtures to the basin (taps, waste etc.)
This completes the installation of the vanity unit.

6 of 8
When installing our wall hung furniture units into a stud wall it is necessary to add
additional support in order to ensure the unit can be securely and safely installed.
Install the wall bracing at a minimum of 2x6” and the width of the unit ensuring
that there are an adequate number of stud beams to anchor the bracing.
Mark the centre line and continue to finish the wall as required. Mount the unit
using suitable fixings for your wall type.
Imperial strongly recommend to mount the unit using the wall bracing method on
cavity and stud walls.
The furniture unit is tested to withstand a maximum load in line with guidance set
by European standards.
If the furniture is fixed using a basin frame Imperial cannot guarantee the load
bearing capacity of the unit.
Fitting onto a stud wall
Wall bracing
(2x6 minimum)
Finished floor
Finished wall
Wall bracing
(2x6 minimum)

7 of 8
Care & Maintenance
You have just acquired a high quality and expensive piece of furniture and are about
to put it in the most hostile environment in the house! We have been producing
these fine products for many years and our experience is that they will give years of
pleasurable service if a few simple measures are taken to look after them.
Ceramic:
The glazed finish of your sanitaryware should be cleaned after use by applying
a little cream type cleaner. Apply using a sponge or damp cloth and rinse
thoroughly with clean water. Cleaners containing abrasive materials
should be avoided.
Metal:
Parts with Chrome/Gold finish should be cleaned with a damp soft cloth only.
The use of detergents and abrasive cleaning agents should be avoided as these
will cause damage to the finish of the metal.
Care and cleaning of Imperial products
To preserve the finish of Gold and Nickel plated items Imperial recommend the use
of soap and water only for cleaning and ensure that the product is thoroughly dried
after with a soft lint free cloth. Do not use abrasive polish or cleaners.
Commercial/domestic spray cleaners are not to be used as they contain strong chemicals
that will burn and even remove the plated finish.
In the event of strong bleaches or cleaning products being used resulting in plated
finish being chemically burnt/tarnished will be void any warranty or guarantee.
Care should be taken with hand gels and mouth wash as they contain alcohol which
will burn and tarnish the plated finish.
In the event of spillage as listed above revert to the cleaning instruction above.

Wood:
Bathroom furniture can be wiped over using a damp cloth and dried with a soft
duster. The use of polishes using silicon or any abrasive materials can damage
the wood finish. Natural wax polishes should be used sparingly and applied
using a soft dry cloth.
Always use your best efforts to keep the wood surface dry. The finish will
deteriorate and the underlying timber could become permanently stained if
subjected to long term contact with water.
Dark and light oak oiled finishes
Units and cabinets are manufactured from solid wood and have been crafted
and finished by hand within Imperial’s factory.
The finish is applied by hand onto solid wood to maintain the natural look of
the grain. The surface is not finished with a clear lacquer.
Like all hand made quality furniture within the home, care needs to be taken
against spillage otherwise the finish could become compromised resulting in
permanent staining of the wood surface.
Spillages should be wiped dry imediately after use with a soft lint free cloth. In
the event of staining or damage a care kit or recovery kit is required. Please visit
www.rubiomonocoat.com for advice and sales of these products.

Westbury 1 Drawer Wall Hung Unit
Westbury Open Wall Hung Unit
Technical specification
685
400
680
435
660
490
465
455
685
400
680
660
435
490
465
455

The Imperial Bathroom Company
England
Tel: [phone], Fax: [phone]
www.imperial-bathrooms.co.uk