INDA SaVeri User manual

1 2 3
45
FLOOR &TABLE LAMP
ASSEMBLY INSTRUCTIONS
SEE REVERSE FOR CHARGING INSTRUCTIONS
x 1
x 9
x 9
IF ADDED WEIGHT IS DESIRED FILL WITH SAND WITH FUNNEL
THROUGH HOLE ON TOP OF BASE BEFORE ASSEMBLY
www.saveri.de Page 1 (2016)
@saveri_living

CHARGING INSTRUCTIONS:
1. Place the charging induction plate in a dry, indoor location - DO NOT operate or leave the charging induction plate
outdoors
2. Connect the plug to an electrical wall outlet with an input voltage of AC100V-240V
3. Place the LED lamp directly on top of the charging induction plate so that there is a secure fit - you should see a red (for
charging) or blue light (fully charged) omitted from the LED lamp. If you do not see any light omitting from the LED lamp,
check your electrical wall outlet is working and the LED lamp is correctly placed directly on top of the charging induction
plate
4. The indicator light will turn blue once the LED lamp is fully charged
LED LAMP OPERATING INSTRUCTIONS:
1. Place the LED lamp directly into the top of the lamp (once the lamp is fully assembled)
2. To turn on the LED lamp, turn it over and push the circular rubber button on the base of the LED lamp (this will turn the
LED lamp on or of )
3. The LED lamp will operate continuously for at least 6.5 hours.
4. Recharging time is approximately 6 hours.
TECHNICAL SPECIFICATIONS
Adapter Input: AC 100V-240V 50/60Hz.
www.saveri.de Page 2 (2016)
@saveri_living