InkJetBiz FUZE Instructions for use
1.Use the proper Fuze Solution
2. Please keep children away from the applicator and solution liquid3. Do not mix Fuze Solution with other liquids4. Verify the amount of Fuze Solution required prior to applying to substrate5. Recommended to be used on 100% cotton white and light fabricsNOTICE
CONTENT
In the Box
System Introduction
Fuze Handheld User Operation
Transfer Settings
Q & A
0
08
08
Items Required
1 x Bottle Fuze Solution 0 0
Fuze Handheld System
1 x Fuze Handheld Applicator1
256What You Need
1.Fuze Applicator
2.Fuze Solution
3.T-Shirt7. Parchment Paper4374. Small Paint Roller5. Polyester Fabric6. Acrylic Plate
0 0
1. Open the handheldFuze spray bottle andfill it with 1 liter Fuzesolution2. Pump spray bottle fora few seconds topressurize the bottle,thiswill allow it tocontinually spray.3. Set the Fuze spray bottle nozzle to mist.It is recommended to check this prior to spraying the t-shirt.4. Place the T-shirt on the Acrylic Plate and spray the Fuze ™ solution to the t-shirt area you wish to sublimate your image.It is recommend to spray evenly using50 mls for 16"x20"5. After the Fuze™ solution is sprayed, use a small paint roller to gently push the solution into the fibers.6a. Take the shirt to the heat press and lay down parchment paper on top. Place the Polyester Pabric on top of the parchment paper then press. This will help spread the heat evenly.6b. It is recommended pressing for 15 seconds with a temperature of 385°F.Using polyester fabric on top of parchment paper will help prevent your garments from yellowing. 7. Once its dry, center your printed dye sub image on top of the shirt.Place the polyester fabric to spread the heat and press for 35 seconds at 385°F.
0
9.Your shirt is ready.Note: Fuze coating feel should wear off after 1st wash. Recommended wash settings: Cold wash at low temperature drying.*Repeat steps 2-9 asneeded8. Remove the shirt from the press and let it cool down for one minute, then remove the dye sublimation paper.Transfer Material
SubliMate Dye
Sub Paper
385°F35 ~ 40 s
Cotton 100%
Medium
Heavy
Base MaterialRemarks
50% Cotton - 50% Poly
Printer TemperatureTime
Heat Press PressureRemarks
Piezzo and
Micro TFP
Print Head
GO XPress
1620 SA
Mirror design
before printing.
Place a layer of
fabric on top of
your transferred
image prior to
pressing.
Washing Instructions
Recommended wash settings:
•Cold wash
•Delicate/Low temperature drying or Hang Dry
For any further help, please contact
our support team.
(408) 394-7595
Table of contents
