Innovative Concepts in Entertainment AIR FX Operating and safety instructions

1
Playeld Replacement
Innovave Concepts In Entertainment
10123 Main street, Clarence, NY 14031
WWW.ICEGAME.COM
[phone] Monday through Friday 8:30am to 6:00pm Eastern Standard

2
Remove the side guards:
Remove the four screws that aach the opposite side guard from the marquee. Slide the playeld divider out
of the other side guard slot. Remove the other side guard.
Unlock the cabinet using provided hex wrench.

3
Open the top and disconnect the motor harness from the motor.
Then remove the four bolts holding the blower motor to the playeld and put aside.

4
With two people on each corner, posion the safety braces on each side of the cabinet.
With a third person, remove the pins on the gas shocks. To do this, ip the pin around and slide it down and
out the hole. Then pull the gas shock o the anchor and lay on the ground. Now close the top.
Make sure your two helpers stay securing the safety braces.
PIN

5
Remove the marquee and unplug its harness. Put the marquee aside.
The Allen bolts that hold the hinge to the cabinet are covered by the side decal. Using your nger locate
each Allen bolt hole and use a sharp knife to remove the decal covering the hole. Do not cut the decal larger
than the hole. Remove the Allen bolt. There are nine Allen Bolts.

6
Li the playeld Assembly o the cabinet and onto a pair of saw horses.
WARNING: PLAYFIELD TOP IS VERY HEAVY!
Remove all side rails. To do so, remove the nylon nuts at the boom and li the rails out. Repeat this all the
way around the playeld.

7
Remove all corner rails. To do so, remove the two bolts holding the corner Repeat this all the way around
the playeld.
Li the playeld out. Replace with new playeld. Assembly in reverse. Please note on last page the layout
for the ball deectors proper placement.

8
Ball Deector Mounng Posions
** NOTE ** Color has been changed to red to accent.
SA0185W
LONG
Tone Bar
SA0186W
SHORT Tone Bar
SABOLTKITNEW