insize 7315 Series User manual

MN-7315T-E
7315
WIRELESS TRANSMITTER
OPERATION MANUAL
www.insize.com
V2

①
②
No. 7315-21
③④⑤
back
① Button
② Indicator
③ Plug
④ Serial number
for example,
ID:4018070005
⑤ Product model
21
Introduction
Instructions for use
1
2
3
Button: Press the button to trigger data collection, and send one
data each time.
Indicator: For each successful data transmission, the red light
flashes once.
Plug: Inserted into the data interface of the gage.The applicable
gages for each type of transmitter are shown in the table below.
As shown in the figure, remove the four screws from the cover and load
the CR2032 battery with the positive side facing out.
4Battery installation:
7315-21(7315-22, 7315-30…): transmitters, is connected to our
measuring tool and used with the receiver 7315-2 or 7315-3
to send the measuring value to the computer. A unique serial
number is printed on the side of each transmitter.
digital calipers and digital depth gauges
large digital calipers(range ≤1000mm)
and digital height gauges
digital micrometers
7315-21
7315-22
7315-30
采集按键
Applicable gages
Code Plug
7315-50
7315-50M
7315-60
Applicable gages
Code Plug
high precision digital indicators
digital indicators, digital thickness gages and
digital internal/external caliper gages
No. 7315-21
Connection with gages:
5
There is a velcro sticker being attached to the battery cover of
the transmitter, and another velcro sticker can be attached to the
appropriate position of the gage. Then, the transmitter can be
fixed on the gage with velcro stickers (as shown in the figure
below) to avoid inconvenience in the measurement process.

3
③ 7315-30：④ 7315-50M：
⑤ 7315-60：
digital micrometers digital indicators digital thickness gages
high precision digital indicators
① 7315-21：
digital calipers large digital calipers
② 7315-22：
digital height gauges
For the fixed position of the transmitter, the following ways are
available for reference:
(You can also choose other suitable ways .)
4
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on
, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF warning statement
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.