Intelligent Facility Solutions Dryflow IFSDJ003AC-ANON User manual

INTELLIGENT FACILITY SOLUTIONS
Electric Works, 3 Concourse Way, Sheffield, S1 2BJ
United Kingdom: [phone]
Eire: [phone]
[e-mail]
www.intelligenthanddryers.com

Thank you for choosing our products.
Please read this manual carefully beforeuse.
1. Fill the soap bottle with liquid soap for the first use.
2. Press and hold button until liquid soap is dispensed from the nozzle.
3. Place hand below the nozzle to dispense liquid soap into palm of hand.
The soap dispensers have 4 settings to adjust dispense of soap, the first gear
being the least volume and the fourth being maximum.
Factory default is set at second gear.
Tri-Tap Automatic Soap Dispenser
User & Install Manual
first gear second gear
third gear fourthgear
WALL
CARE AND MAINTENANCE
If the soap dispenser fails to function correctly, firstly check all connections are
tight and free from air leaks. If dispenser still fails to function, place manifold into
a bottle of warm water. Pump the warm water through the dispenser to dislodge
any dried soap residue and then refit manifold into soap bottle.
Water marks and soap residue on polished chrome surfaces are best
cleaned using warm water and a mild detergent. Use a stainless steel
cleaner for brushed stainless steel soap dispensers. Never use an abrasive
cloth to remove stubborn stains. Dry with a soft clean cloth.

Wall
FLOOR
Power Adaptor
Model No.
IFSDJ003AC-ANON
Material
Brass
Power Supply
AC:220V
DC: 6V (4xAA)
Bottle Capacity
1.6-2L
Ambient Temp.
Normal Temperature
Sensor Range
15±3cm
Viscosity
100-3500cp(mpA·s)
Soap Volume
≤2mL/times(four gears)