Invacare 1614 Assembly instructions

1
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage before
using. In case of damage, do NOT use. Contact the
Dealer/Carrier for further instructions.
SAFETY SUMMARY
The following recommendations are made for the
installation of the anti-theft device:
GENERAL WARNING
DO NOT install or use this equipment without
first reading and understanding these in-
structions. If you are unable to understand
the Warnings, Cautions or Instructions,
contact a healthcare professional, dealer
or technical personnel before attempting
to install this equipment - otherwise, injury
or damage may occur.
This kit contains the following:
DESCRIPTION QTY
Anti-TheftTube 1
Half-Clamps 2
Carriage Bolts 2
Locknuts 2
Instruction Sheet 1
INSTALLING THE ANTI-THEFT
DEVICE (FIGURE 1)
1. Loosen, but DO NOT remove the two (2) lower
(Tracer Fixed Front) or the two (2) upper (Tracer 4)
phillipsscrewsthatsecurethebackupholsterytothe
back canes shown in FIGURE 1.
2. Position the half-clamps on the back cane as shown
inDETAIL"A".
3. Makesureofthefollowing:
A. The dimple in each of the half-clamps is
towards the outside of the wheelchair.
B. Thehalf-clamp positioned behind the backcane
isbetweenthebackupholsteryandthebackcane.
C. The half-clamps are positioned between the top
of the skirt guard and the bottom of the armrests
for the TRACER FIXED FRONT.
D. The half-clamps are positioned above the arm-
rest for the TRACER 4.
Anti-Theft Device
Assembly, Installation and Operating Instructions
Model Nos. 1614 and 1714
Phillips
Screws
FIGURE1- INSTALLING THEANTI-THEFTDEVICE
DETAIL"A"
Armrest
BackCane
Anti-Theft Tube
Locknuts
Half-Clamp
Carriage
Bolts
Skirt Guard
Hole
Dimple
NOTE:Position bend
in anti-theft tube
towards inside of
wheelchair.
TRACER FIXED
FRONT
Back Uphol-
stery
Back
Upholstery
NOTE: Position bend
Inanti-thefttube
towardsinsideof
wheelchair.
Phillips
Screws
TRACER4
Half-Clamp

4. Install the carriage bolts that secure the half-clamps
togetherandlooselysecurewiththelocknutsprovided.
5. Position the anti-theft tube between the half-clamps
asshowninDETAIL"A"inFIGURE1.
WARNING
Make sure the holes in the anti-theft tube
line up with the dimples in the half-clamps.
If the holes and dimples DO NOT line up,
injury or damage can occur.
6. Lineuptheholesintheanti-thefttubeandthedimples
in the half-clamps.
CAUTION
DO NOT overtighten attaching hardware.
Damage to anti-theft tube can occur.
7. Tightenthecarriageboltsandlocknuts.DONOTover-
tighten.
FIGURE2 - USING THEANTI-THEFT DEVICE
USING THE ANTI-THEFT DEVICE
(FIGURE 2)
WARNING
NEVER maneuver an occupied wheelchair
by using ANY part of the anti-theft device.
Serious injury or damage can occur. ALWAYS
use the handles of the wheelchair when
maneuvering an occupied wheelchair.
NEVER Use any part of
this anti-theft tube to
Manuever an Occupied
Wheelchair.
ALWAYS Use
the handles of
thewheelchair
to Manuever
an Occupied
Wheelchair.
Invacare Corporation
USA Invacare and Yes, you can are trademarks of Invacare
Corporation.
© 2000 Invacare Corporation
Form No. 97-147 Part No. 1075583 Rev B (1) 7/00