Isenberg 250.2000 User manual

InstallationManualFor250.2000-ThreeHoleFaucet
MadeForResponsibleLuxury
NOTICETOHOMEOWNER
• We recommendthatthisproductisinstalledbyaqualified 
professionalplumber.
•Pleasecheckthisproductimmediatelytoensurethatithas
notbeendamagedandiscomplete.Beforeinstallation,please
makesurethisproductisthecorrectmodelandyouhaveall
thepartsrequiredforinstallationanduse.
•Pleaseflushthewatersystemtoensurethatnometalswarf,
solder,andotherimpuritiescanentertheproduct.
•
Turnoffwatersupplybeforecommencingwork. 
•Pleasereadtheseinstructionscarefullyandretainforfuture
reference.
BEFOREYOUBEGIN

•Youmustobservealllocalplumbinglawsandcodes.

•Donotinstallthisproductifitdoesnotmeetplumbingcodes.
•Shutoffthemainwatersupply.

www.isenbergfaucets.com
Ver. 2.53

MadeForResponsibleLuxury
INSTALLINGTHEFAUCET
www.isenbergfaucets.com
Step 5
Connect the hoses (2) to the bottom of the
hot and cold end valves (1 & 3), as shown.
Carefully bend the hoses (2) to t in the
available space, and carefully thread the
hose (2) couplings onto the sides of the
connector (4) of the spout assembly.
Tighten all connections with a wrench.
Step 6
Important: After installation is completed,
remove aerator with plastic wrench. Turn
on water supply and allow both hot and cold
water to run for at least one minute
each. While water is running, check for leaks.
Replace aerator. This ushes away any
debris that could cause damage to internal
parts.
OR
OR
Step 4
Connect the hoses (2) to the bottom of the
hot and cold end valves (1 & 3), as shown.
Carefully bend the hoses (2) to t in the
available space, and carefully thread
the hose (2) couplings onto the sides of the
connector (4) of the spout assembly. Tighten
all connections with a wrench.
Step 1
Shut o water supply. Remove old faucet.
Clean the surface in preparation for new
faucet.
Step 2
Place the spout assembly (1) through the
middle mounting hole in the sink. Secure the
spout assembly (1) with washers (2) and nut
(3). Tighten the connector (4) over the inlet
shank of the spout assembly (1).
1
2
3
4
Step 3
From underneath the deck, insert the valve
body (3) , rubber washer (1) and mounting
nut (2) through the hole on the right (cold)
side.Place handle assembly (4) onto the right
(cold) valve stem (3). Then thread the
assembly (4) onto the valve body (3). Place
the other handle assembly onto the left (hot)
valve stem and install the same way. Hot side
end valve is red labeled.
Note：
With the Cartridge in the "O" position,
align Handle to desired "O" position, and
engage the splines of the Valve Cartridge
into the Handle Assembly.
1
23
4
OFF
ON
4
2
1
3
3
12
2
3
1