ITZA PD Series User manual

Box contents
Speaker
Cover Plate
Cover Plate
Screws (4)
Hanging Hardware
Tap Switch
Hanging Bracket
Terminal
Block
Weather plug
1 Speaker
1 Cover Plate w/ 3 screws
1 Hanging kit
Thank you for purchasing ITZA speaker.We take pride in our product and are committed to provide years of entertainment pleasure.ITZA-PD series
is a 70/100V music distributed-line system offering a superb sound quality.This booklet covers the necessar y information for an intuitively easy
installation guide.
I
T
M
Introducon

1. Unpack speaker and
Gripple cable mounting
hardware.
2. Thread hanging or safety
cable through Gripple cable
mechanisms as shown.
3. Attach the hanging cable
by securing it and safety
cable to structure as shown.
4. Thread cable end(s)
through Gripple cable
mechanisms as shown.
8. Connect signal wires to (+)
and (-) inputs.
11. Tighten all three (3)
plate in place.
5.
7. Attach snap hook by
inserting one end through
the hold on mounting
bracket.
6. Slide cover plate over
hanging and safety cables
and run signal wire through
center hole.
Switch is preset to maximum
70V (100V) mode.
Adjust speaker hanging
height with Gripple cable
mechanism. Pull to tighten &
press button on Gripple cable
as shown to loosen or adjust.
12. Done.
1.
2.
10. Place cover plate onto
top of speaker and slightly
rotate until alignment
indicators meet.
screws tolock cover
I
T
M
Installaon
INPUT
1. Unpack speaker and
Gripple cable mounting
hardware.
2. Thread hanging or safety
cable through Gripple cable
mechanisms as shown.
3. Attach the hanging cable
by securing it and safety
cable to structure as shown.
4. Thread cable end(s)
through Gripple cable
mechanisms as shown.
8. Connect signal wires to (+)
and (-) inputs.
11. Tighten all three (3)
plate in place.
5.
7. Attach snap hook by
inserting one end through
the hold on mounting
bracket.
6. Slide cover plate over
hanging and safety cables
and run signal wire through
center hole.
9. Select desired tap position.
Switch is preset to maximum
70V (100V) mode.
Adjust speaker hanging
height with Gripple cable
mechanism. Pull to tighten &
press button on Gripple cable
as shown to loosen or adjust.
12. Done.
10. Place cover plate onto
top of speaker and slightly
rotate until alignment
indicators meet.
screws tolock cover
I
T
M
Installaon
X
INPUT
9. Select desired tap position.

Limited Lifeme
ten(10)
T
M
WWW.ITZAUDIO.COM