JEC Products ULTRALITE BEEHIVE PRO STUDIO User manual
JEC Products has proudly always been a Green Company
•A producer of highly energy efficient kiln’s
•All production is performed in an energy effect facility
•Products are made of recyclable recycled materials
•Packing materials are recyclable
•Components are made in the USA.
Specifications:
•Kiln stands 6” Tall x 6.25” Round
•The kiln body consists of a high insulation ceramic fiber.
•Weights less than 2 pounds
•Firing surface is 3.5” in diameter by 1.5” high
•The 3.5-inch diameter element maintains a 1600oF temperature.
•Standard 120 Volt household power.
•The 250 Watt Kiln cost less than .02 cents per firing to operate.
•CE Compliant.
Firing instructions: https://jecproducts.com/instructional-pdfs
SAVE THESE IMPORTANT INSTRUCTIONS
Manufactured by JEC Products® USA
ULTRALITE
BEEHIVE PRO STUDIO
Fine Jewelry Kiln ©
Made in the USA
INTRODUCTION
Congratulations on your purchase of the UltraLite Beehive Pro Studio
Fine Jewelry Kiln. The Beehive Pro Kiln is used for Fine Metals
Granulation, Enameling, Firing Metal Clay, Keum-Boo, Annealing and
Fusing Glass.
IMPORTANT SAFEGUARDS
•Do not touch hot surfaces. Care should be taken in the placement
of the hot cover and spatula.
•To protect against risk of electrical shock, do not immerse cord,
plug or heating unit in water.
•Do not operate Kiln with a damaged cord or ceramic body.
•Close supervision is necessary when using near children.
•Safety glasses should be worn when using. Clear safety or reading
glasses should provide adequate UV protection.
•The use of accessories attachments not recommended by JEC will
void warranty and could cause injury.
•Do not leave Kiln unattended during use.
•Unplug from outlet when not in use and allow the Kiln to cool
PREPARING THE ULTRALITE KILN FOR USE
•If an extension cord is used it should be placed so that it will not be
tripped on accidentally.
•When using the Kiln provide adequate air space above and on all
sides.
•On surfaces that heat is a problem an insulated hot pad is
recommended.
•First time only, Plug the Kiln in and leave it uncovered for 30
minutes, then cover for 15 minutes. This will allow the cement to
cure and the manufacturing oils to burn off, there will be a very
slight odor, You’re now ready to use your Kiln.
•Preheat time with the lid on is 60 minutes to reach the maximum
maintained temperature of 1600oF.
There are several new accessories complete with instructions
allowing for more jewelry making options:
•Ceramic Inserts to fire Metal Clays.
•Red Brass covers to Keum-Boo Gold Foil onto Silver.
•Wire Enameling Trivets.
•Flat Cover used to increase kiln temperature by100oF.
•Temperature controller.
CARE OF YOUR KILN
•When storing your Kiln its best to cover your kiln in a plastic bag or
moisture proof container.
