JEDDO & SONS Aspen BH89 User manual

Aspen (BH89)
User Manual
Page 1/2
(1) Pull the crown out to the 1st position and turn the crown to set the hour and minute hands
(2) Push the crown back to the normal position to start the watch
S E T T I N G T H E T I M E
Remove protective plastic and safety tab on watch crown
S T A R T H E R E
NORMAL CROWN
POSITION
HOUR
HAND
MINUTE HAND
SECOND
HAND
1ST
POSITION
GENTLY PULL ON CROWN
TO CHANGE POSITION
A D J U S T I N G T H E L E N G T H O F T H E W O O D E N S T R A P
With the watch facing upwards, insert the screwdriver pin gently into the small hole on the
right side of the strap link you want to remove. Turn the screwdriver handle clockwise until the
thin metal pin inside the strap link comes out on the other side. Disconnect as many links as
you need to reduce the length of the strap to your wrist size or add the additional links provided
in the box to increase the length of the strap.
Screwdriver
handle
Screwdriver pin

Pull the quick-release
lever
Gently pull the strap away
Your watch is fitted with a wooden strap but also comes with an additional leather strap in the
box. Each of the straps has a quick-release spring bar which you can pull using the quick-
release lever, allowing you to easily take the strap on and off in a few seconds.
C H A N G I N G T H E S T R A P
Aspen (BH89)
User Manual
To attach a strap, first insert the spring bar pin opposite the quick-release lever into the
case hole. Then, gently pull the quick-release lever to align the pin on the other side with
the case hole until you hear a click. Check that the strap is secure by gently pulling on it.
To remove the strap, pull the quick-release lever and pull the strap away gently.
Align the pin with the case hole
until you hear a click
Insert the spring bar pin
into the case hole
Pull the quick-release lever
Page 2/2