John Lewis Lotta Cot User manual

Lotta Cot
Instruction manual
IMPORTANT
RETAIN FOR FUTURE REFERENCE
PLEASE READ CAREFULLY

2
Thank you for purchasing this Lotta Cot. Please read the instructions and warnings carefully
before use to ensure safe and satisfactory operation of this product.
Your child’s safety is your responsibility. If you have a query with this product or require
replacement parts, please contact your nearest John Lewis department store.
Lay out the parts on a soft level surface and compare to the part and fixings checklist on
page 2. Do not discard any packaging until you are sure that you have all the parts.
Keep children clear during assembly as pack contains small parts which may present a
choking hazard.
Recommended mattress: 60 x 120cm.
This product complies with BS EN 716-1:2008
Fixings
Parts
You will need:
1 x Cross-headed screwdriver
1 x Allen key (supplied)

3
Step 1
Fixing 2 x 4 pieces
The cotbed has a choice of three mattress base positions. The lowest base position is the
safest.
Using a cross-headed screwdriver, insert the assembly dowels (fixing 2) to the bed ends
(parts A) at the desired mattress height.

4
Step 2
Fixing 1 x 8
Attach the cot sides (parts C) to the high bed ends (part A) using the bolts (fixing 1) and the
allen key (supplied). This step will be easier if you have someone to hold the cot sides and
high bed ends together while you screw in the bolts.

5
Step 3
Lower the mattress base (part B) onto the assembly dowels (fixing 2) at each corner of
the bed ends (part A) and push down firmly.

6
Care and maintenance
Your furniture may be cleaned by wiping with a damp cloth and drying with a soft clean
cloth.
Do not use abrasives, bleach, alcohol or ammonia-based household polishes.
Take care when handling or moving the furniture. Careless handling may cause damage.
Safety notes
Furniture can be dangerous if incorrectly installed. Assembly should be carried out by a
competent person.
Keep children clear during assembly as pack contains small parts which may present a
choking hazard.
Warning: Be aware of the risks of open fires and other such sources of strong heat, such as
electric bar fires, gas fires, etc. in the near vicinity of the cot.
Warning: Do not use the cot if any part is broken, torn or missing and use only spare parts
approved by the manufacturer.
Warning: Do not leave anything in the cot or place the cot close to another product, which
could provide a foothold or present a danger of suffocation or strangulation, e.g. strings,
blind/curtain cords, etc.
Warning: Do not use more than one mattress in the cot.
The lowest base position is the safest, and should be used as soon as your baby is old
enough to sit up.
The thickness of the mattress chosen must not reduce the internal depth (from the top of
the mattress surface to the top of the side) to less than 500mm with the base in its lowest
position or 200mm with the base in the highest position. The high bed ends of the cotbed
have a mark indicating this height.
The mattress should be no more than 30mm shorter or narrower than the internal length
or width of the cotbed.
All assembly fixings should always be tightened properly. Periodically check all fixings to
ensure none have come loose, and that there is no risk of clothing or parts of the body
becoming snagged or trapped.

7
To prevent falls, when the child is able to climb out of the cot, the cot should no longer be
used for that child.
Do not allow your child to jump on the cot. This may result in damage to the furniture
and/or injury to your child.
Retain this information leaflet for future reference.
John Lewis Partnership
171 Victoria Street
London
SW1E 5NN
www.johnlewis.com