Johnson Hardware 1521 User manual

1. MARK DOOR Mark door for 2-1/8" bore on face of
door, and 15/16" bore on edge of door approximately
36" above floor. *NOTE: LOCK WILL FIT AND
FUNCTION PROPERLY IN EITHER 15/16" OR 1"
BORE FOR LATCH BOLT.
2. BORE HOLES Bore 2-18" hole in door face (Boring
from both sides of door to prevent splitting). Bore
15/16" hole in door edge 3-5/8" deep. (Make sure
15/16"* mark is center of door edge). Mark and
mortise for latch 1/8" deep.
3. REMOVE STRIKE Remove strike plate from lock by
depressing latch release.
4. INSTALL LOCK Install latch bolt by depressing nylon
locking button on bolt to clear 15/16"* hole. Be sure
that locking button is on the locking side desired.
A/ Place Plate with locating blocks opposite locking
side into 2-1/8" bore. Be sure that the “Safety Release
Hole” is toward rear of door and away from latch. Take
other face plate with locking
slot, insert “Locking
Button Extension”
into locking slot.
Place locking slot
face plate and
“Locking Button
Extension” over
locking button and
secure with 1/4"
screws provided.
B/ Snap “Latch Button
Extensions” onto latch
button ends.
C/ Fasten latch plate in mortise
with 3/4" screws provided.
5. INSTALL STRIKE Slide pocket door closed, hitting
jamb to mark location. Drill 15/16" hole 1" deep in
center of marks made by latch. Place strike plate in
15/16" hole, making sure plate is plumb with jamb,
then mark and mortise, 1/8" deep. Secure with 3/4"
screws provided.
L.E. JOHNSON PRODUCTS, INC. • 2100 STERLING AVE. • ELKHART, IN 46516 • 574-293-5664
www.johnsonhardware.com
IN153PDL
Rev. 9/05
HOW TO
INSTALL POCKET DOOR PRIVACY LOCKS
Privacy Pocket Door Lock 1534
For 1-3/4" Thick Doors
Important: Do Not Remove Screws from Locating Blocks on Plate
HARDWARE