JumpSport Fitness Trampoline 300 Series User manual

1
1.888.567.5867
www.fitnesstrampoline.com
Use trampoline only with mature, knowledgeable supervision.
WARNING
Fitness Trampoline™ User’s Manual
Arched Leg, Non-Folding Models
Read these materials prior to assembling
and using this rebounder trampoline
Retain address information for future use.
JumpSport, Inc.
2055 South 7th St., Suite A.
San Jose, CA 95112 U.S.A.
Retain address information for future use. Covered by one or more of the following US Patents: No.6.840,891, No.D666,266, and
No. D680,609. Other US and International Patents Pending.
Instruction Manual P/N: INS-P-11656-06A
Copyright © 2003-2023, by JumpSport, Inc. All rights reserved.
(Pictures are for illustration purposes only and may not match actual product.)
 WARNING: Users should consult with a physician beforebeginning any exerciseor conditioning pro-
gram.
 If user feels faint or dizzy, immediately stop using the rebounder trampoline.
 Avoid bouncing when tired. Take breaks often.
 Use only in a well lit area by responsible, mature, non-intoxicated persons.
 Never use trampoline on an un-level surface. Only use when dry.
 Keep away from objects which could interfere with safe use. Clear obstructions underneath, above, or around the
rebounder trampoline. Check for adequate vertical clearance (avoid low ceilings, ceiling fans, light fixtures, etc.) and
lateral clearance (avoid furniture, lamps, walls, other trampolines, etc.).
 Inspect before each use. Replace or adjust any loose, worn, defective, or missing parts.
 Do not jump on and off the trampoline. Do not use the trampoline as a springboard to or from other objects. Do not
step on the frame when getting on and off the trampoline.
 Stop bounce by flexing knees as feet come in contact with the trampoline bed. Learn this skill before attempting oth-
er more advanced moves. Control is more important than bounce height.
 For information concerning skill training, contact a qualified fitness trampoline instructor.
 Store and protect trampoline from unauthorized use.
 For additional information, contact us at JumpSport.com or 1.888.567.5867.
It is the responsibility of the purchaser to become familiar with all of the information in this booklet, to convey the warnings to all
users, and to enforce JumpSport’s rules for safe use.
Commercial Use
Only models in our 300 and 500 Series are for commercial use, and are subject to shorter warranty periods (see Warranty section).
DO NOT attempt or allow
somersaults. Landing on the
head or neck can cause
serious injury, paralysis or
death, even when landing in
the middle of the bed.
DO NOT allow more than one
person on the trampoline.
Use by more than one person
at the same time can result in
serious injury.
If you wish to change the firm-
ness of your rebounder, turn it
upside down. Then pull cord
tighter to different knot, ac-
cording to chart. See picture
for firmness settings.
IMPORTANT: Grab cords
with both hands and be sure to
re-position bungee so tension
remains evenly distributed.
Not re-positioning will cause
cord to wear unevenly.
FlexBounce III = 3 knot cord
FlexBounce VII= 4knot cord
How to Adjust
FlexBounce™ Cords
(if applicable)
FlexBounce III Configurations FlexBounce VII Configurations
Softer Soft Setting on all FlexBounce connectors Soft Setting on all FlexBounce connectors
Medium Setting on every other connector Medium Setting on every other connector
Soft / Medium / Medium Settings (repeat pattern)
Medium Setting on every connector Medium Setting on every connector
Firm Setting on every other connector
Medium / Firm / Firm Settings (repeat pattern)
Firmer Firm Setting on every connector
Soft Setting
(factory setting) Medium
Setting Firm Setting
FlexBounce
connector
FlexBounce VII
shown here

2
Non-folding Trampoline Leg
Installing Leg Pieces
WARNING: Periodically check all
leg mounting bolts and retighten
if necessary. All bolts should be
tight prior to using the rebounder
trampoline.
IMPORTANT: The leg
plugs cover pre-installed
hardware. Please DO NOT
remove them unless in-
structed to do so for re-
placement purposes.
Note: Keep Allen
wrench to remove or
re-tighten legs, as
needed.
6mm Allen wrench
6mm Hex drill bit
(not shown)
1) With trampoline upside-down, fit leg sockets over stud on trampoline frame.
Notch in leg socket lines up with key on stud.
2) Insert the end of the supplied 6mm Allen wrench into the hole in the rubber leg
plug and engage the Allen bolt head inside the leg.
3) Securely tighten Allen bolts with 6mm Allen
wrench.
If you are going to install an exercise handle,
turn to next page for installation. When all legs
are installed, turn your rebounder over.
The JumpSport Fitness
Trampoline is now ready for use!
IMPORTANT: Bolts may offer re-
sistance when tightening. No threads
of the bolt should be exposed when
bolt is properly installed. Use lever-
age with the provided 6mm Allen
wrench to ensure safe and proper
installation.
Elastic cords are wear items that need to
be replaced from time to time. Their life
expectancy is determined by:
 The way the trampoline is being used
(jumping for height vs. controlled, fit-
ness-style bouncing vs. jogging)
 The user weight and height
 Frequency of bouncing
 The type of cords used (standard or
extra-firm)
We are often asked how long your cords
will last. The answer is, it depends.
Some of our customers use a set for 9
months, while most will use a set for
many years. Similar to running shoes or
car tires, the more you use them and the
harder you use them, the faster they
need to be replaced.
A Note About
Expected Cord Life
Leg Plug
Key on Stud
1 2

3
** Installing Stabilizer Handle **
WARNING: If you have handle legs
attached, do NOT attempt to use the
rebounder without first properly in-
stalling the rest of the handle bar pieces.
2) Connect side handles to top handle, and secure
both sides with snap buttons to create a “top
assembly”.
Snap Button
Top Handle
39”: HAN-A-20841-00
44”: HAN-A-20164-03
Side Handle
HAN-A-21051-00
CAUTION
Avoid Injury.
 The exercise handle bar is not designed to sup-
port your entire weight. It is to aid with balance
and provide exercise versatility.
 If you have handle legs attached, do NOT attempt
to use the rebounder without first installing the
rest of the handlebar pieces.
Large Thumb Screw
SCR-P-11707A
** Installing Stabilizer Handle **
WARNING: If you have handle legs
attached, do NOT attempt to use the
rebounder without first properly in-
stalling the rest of the handle bar pieces.
Large Thumb Screw
SCR-P-11707A
1) Locate the normal leg closest to the Fitness Trampoline logo. At the adjacent normal legs is where the 2 handle legs will be in-
stalled as shown above. Turn trampoline upside-down, fit handle bar leg socket over stud on trampoline frame, and securely tighten
Allen bolts with a 6mm Allen wrench as shown on previous page. The Fitness Trampoline logo may not be exactly centered between
the 2 handle legs as shown above.
2) Connect side handles to top handle, and secure
both sides with snap buttons to create a “top
assembly”.
Snap Button
BUT-P-21049-00
Top Handle
39”: HAN-A-20841-00
44”: HAN-A-20164-03
Side Handle
HAN-A-21051-00 3) Lower top assembly into handle legs. You may have to rotate
entire top assembly 180 degrees for holes to line up. Adjust
height as necessary, before securing with large thumb
screws.
Your exercise handlebar is now installed!
To remove the handle, follow the installation instructions in reverse order.
CAUTION
Avoid Injury.
 The exercise handle bar is not designed to sup-
port your entire weight. It is to aid with balance
and provide exercise versatility.
 If you have handle legs attached, do NOT attempt
to use the rebounder without first installing the
rest of the handlebar pieces.
Handle Leg
LEG-A-20324-02

4
What is covered by this warranty? This warranty covers any defects in materials or workmanship on all of the compo-
nents of a new JumpSport Fitness Trampoline system, and is extended exclusively to the original retail purchaser.
How long does this coverage last? Warranty coverage for each component of a new JumpSport® Fitness Trampoline
begins from the original date of purchase and lasts as follows
How to submit a warranty claim for defective parts:
1) If you notice a defective, missing, or damaged part when first receiving your product, call the JumpSport Customer Service
department at 1.888.567.5867 or email [email protected] within 10 days of delivery of merchandise. You may be asked to
submit photographs and/or proof of purchase for verification.
2) After using the product, if a qualifying warranty part replacement is needed, customers are required to complete the Warranty
Request Form online. Once submitted and reviewed, JumpSport will either repair or replace such parts at JumpSport’s discretion.
To determine eligibility for warranty replacement, you may be required to either submit photos of the part or send the part to one
of our designated service centers.
3) JumpSport will make a final determination whether the part is covered by this warranty. We reserve the right to examine photo-
graphs or physical evidence concerning parts claimed to be defective prior to making a final determination concerning the claim. A
repaired or replacement part will be returned to you. (Shipping charges may apply.) Please allow 3 to 4 weeks for delivery.
What is not covered by this warranty? This warranty covers new products purchased as a complete system; it does not cover
replacement parts. This warranty also does not cover expenses of on-site labor, shipping costs, travel, assembly or disassembly,
or other charges associated with the repair or replacement of covered components. Further, this warranty does not cover any
problem that is caused by abuse, misuse, commercial or public use of 200 Series models, ordinary wear and tear, outdoor use,
weathering, acts of God (such as wind and lightning), failure to follow directions, improper installation, improper maintenance, or
any silk screened graphics. Rust is a natural occurrence with any steel product and is likewise not covered by this warranty, to the
extent that it does not affect the structural integrity of the part.
JUMPSPORT IS NOT RESPONSIBLE OR LIABLE FOR INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES ARISING
OUT OF OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THE PRODUCT OR OTHER DAMAGES WITH RE-
SPECT TO ANY LOSS, INCLUDING BUT NOT LIMITED TO ECONOMIC LOSS, LOSS OF PROPERTY, LOSS OF REVENUE
OR PROFITS, LOSS OF ENJOYMENT OR USE, COST OF REMOVAL, INSTALLATION OR OTHER CONSEQUENTIAL DAM-
AGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAG-
ES. ACCORDINGLY, THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
THE WARRANTY EXTENDED HEREUNDER IS IN LIEU OF ALL OTHER WARRANTIES AND ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE IS LIMITED IN ITS SCOPE AND DURATION TO THE
TERMS SET FORTH HEREIN. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY
LASTS. ACCORDINGLY, THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
*Only the models in our 300 and 500 Series of Fitness Trampolines are approved for commercial use. When used in a
commercial setting, the commercial warranty applies.
Private Use Commercial Use
(Series 300/500 Only)
Steel Frame & Legs Lifetime 5 years
Series 200 & 400 Jumping Surface and EnduroLast Cords* 2 years* n/a
Series 300 Jumping Surface and EnduroLast Cords* 3 years* 12 months* (Except the 370)
Series 300 PRO Jumping Surface and EnduroLast Cords* 4 years* 18 months* (Plus the 370)
Series 500 PRO Jumping Surface and EnduroLast Cords* 5 years* 18 months*
All other components (including hinges) 1 year 1 year
4
*Mat and cord warranty are limited to only one (1) usage replacement during applicable period.
Limited Warranty