Cautions & Safety Measures
• Install the product in a horizontally maintained place.
• This prduct is for indoor use only.
• Install the product in a place where sunlight, rain, snow and dust can be avoided when using outdoors.
• Install the product in a place where the temperature effect is minimal.
• This product requires warm up and use the product after 90 minutes from turn on.
• The manufacturer will not be held responsible for damages from wrongful use.
Please read the instruction manual carefully before using the product to prevent damage and accidents
This instruction manual contains important information on the safe use and maintenance of the product
Correct Usage Instructions
• Check for external defects before use.
• This product is for 220 V only - Be sure to use a grounded 220V outlet for the power plug.
• Do not install or use the defective product.
• Check the voltage and frequency before plug in power.
Product use with wrong voltage, frequency or rated current may cause electrocution or fire .
• Any uncertainty, please consult with electrician or manufacturer.
Technical Safety Instructions
9. Cautions & Safety Measures
How to Use Hand Sanitizer Dispenser
1. Place both hands under the hand sanitizer dispenser
2.Hand sanitizer will be dispensed automatically within 1 second
3. Remove hands after hand sanitizer is dispensed
4. Dry hands well about 10 seconds
Cautions & Trouble-Shootings
Hand Sanitizer Supplement Light On
Trouble Signs Cause & Solutions
Open the door and refill the hand sanitizer
Body temperature measurement
result is inaccurate
(Fever check result is inaccurate)
For accurate body temperature measurement(fever check),
allow 90 minutes warm up after turn on
Opening mouth or exhaling while body temperature measurement
(fever check) effects in measurement result
If trouble continues, please consult with the supervisor(manufacturer)
Refer to a qualified professional(manufacturer) for repair of the product in accordance with the safety regulations
Repairs by unqualified personnel may be dangerous, and the manufacturer will not be held responsible
for the damages from the reparis by unqualified or unauthorized personnel
8. How to Use
How to Use Thermal Face Recognition Camera
1. Look at the camera with the distance of 0.5 ~ 1.0 meter
2. Make sure hair doesn't completely cover eyebrows
3. If the visitor's fever is within the normal range, the camera and the LED of K-Gate light green
- If the visitor's fever is in the abnormal range, the camera and the LED of K-Gate light red
4. Pass the K-Gate after "Go-Through" message is heard
