K Tool International KTI-74394 User manual

KTI-74394
Industrial Jump Starter
& Power Bank
WARNING:
WARNING:
Cancer and Reproductive Harm-
www.P65Warnings.ca.gov

1） LED Flashlight
2) LCD Display Screen
3) Multi Volt Digital Charge Port 12V/16V/19V
4) Mode Switch
5a) USB Digital Charge Port 5V/2.1A DC
5b) USB Digital Charge Port 5V/2.1A DC
6) Charging Input Port
7) On/Off Switch
8) Vehicle Jump Port
WARNING:

Size: 7.32" (186mm) x 3.5" (89mm) x 2.56" (65mm) Power Pack only
Weight: 2.2 lbs (1 kg) Power Pack only
Battery: 12v Lithium polymer 30,000mAh (111WH)
Current: 1800A Peak Cranking, 800A Start Cranking
Output: Vehicle Jump Port 12vDC
Digital Charging Ports: 12V/16V/19V, USB 5V/2.1A, USB5V/2.1A
Battery Chargers: 15V/2A AC; 15V/2A DC
Recharge Time: 4 hours with AC charger; 8 hours with DC charger
Charge Indicator: Backlit LCD Display Screen
Self Discharge Rate: Approx. 0.2v/month depending on ambient
storage temperature
Protection & Safety: Reverse Current, Reverse Polarity, Short Circuit,
OverTemp. OverCranking, Surge, Voltage Differential, Overload Reset,
OverCharge, and Overdischarge
LED Flashlight: 4 Models - Steady, Slow Strobe, Fast Strobe, Off
FEATURES

A) SMART CABLES D) MULTI-VOLT DIGITALCONNECTORS
E) 12-15V DC CAR CHARGER
B) 100-240VAC/15V CHARGER
F) OBDII CABLE
C) USB MULTI-CONNECTOR
D)
MULTI
-
VOLT
DIGITAL
CONNECTO
RS
E)
12-
15V
DC
CA
RC
HAR
GER
INCLUDED ACCESSORIES

USING POWER BANK
CHARGING THE UNIT
1. Use the 15V ACAdaptor to connect the unit to anAC home outlet
or the cigarette lighter adaptor to connect the unit to the vehicle’s
cigarette lighter socket.
2. Slide ON the POWER switch to monitor charging progress on the
screen. The display shows 100% when charging is complete.
3. Disconnect the portable power bank unit from the AC adaptor.
To preserve battery life, fully charge the Power Bank every three
months.
WARNING
THE POWER PACK IS NOT TO BE USED AS A PERMANENT
OR FIXED POWER SUPPLY IN PLACE OF THE ORIGINAL
BATTERY IN THE VEHICLE OR DEVICE.
Please read the User Manual and all Instruction Cards and
Labels on this product before using your Portable Power Bank & Jump
Starter.
Only use this product as per the Instructions provided.
Only use the Battery Chargers supplied with this product. The use of any
other Battery Charger is strictly prohibited, and could cause catastrophic
battery cell damage or serious injury.
CHECK BATTERY CAPACITY
1. Slide ON the POWER switch.
2. Press POWER button without any devices connected to the char-
ger.
3. The number on the LED display indicates the power in the
battery.

JUMP START A VEHICLE
1.Slide ON the POWER switch and make sure the Power Bank is
fully charged.
2.Turn off all accessories on the vehicle (radio, air conditioner, etc)
3.Connect the jumper cable’s RED clamp to the POSITIVE post of
the vehicle battery.
4.Connect the jumper cable’s BLACK clamp to the NEGATIVE post
of the vehicle battery.
5.Insert the jumper cable connector into the Power Bank’s 12V
6.Turn the vehicle ignition key for 3 seconds only. If the vehicle
starts:
•disconnect the clamps from the battery.
• Leave the ignition on for a few minutes, then turn off the
vehicle.
7.again.
CHARGING A 5V USB DEVICE (TABLET, CELL PHONE, ETC.)
1.Slide ON the POWER switch. Connect 3-1 USB connector to the
portable power bank unit.
2.Connect your device to either the miniUSB or microUSB cable.
3.The portable power bank unit begins to charge your device.
TURN ON FLASHLIGHT
1. Slide ON the POWER switch. Press and hold POWER button to
2. Press POWER button again to cycle through the 4 modes: Steady,
Slow Strobe, Fast Strobe, and OFF.
CHARGE DC 12V/16V/19V DEVICES
Slide ON the POWER switch. Press POWER button to select the
desired output voltage (DC 12V/16V/19V). Insert a connector cable
(not included) to DC Output 2 to charge the desired device.

MAINTENANCE
Use common sense when caring for your Power Pack. Be sure the
connectors and jacks remain clean and free of debris. Unplug the
Power Pack after charging. Slide OFF the POWER switch and store the
Power Pack and its accessories in the carrying case provided.
BATTERY DISPOSAL
The battery is self-contained and not consumer replaceable. The battery
must be disposed properly when it no longer holds a charge. Proper
charging practices will increase the life of the unit.
TROUBLESHOOTING
IF... TRY THIS...
My items are not recharging/ • Recharge the Power Pack.
•Verify that your items are connected
correctly.
I haven’t used my Power Pack
in a while, and now the unit
is completely drained.
You may have accidentally put it away with it
powered on. Recharge it.
SPECIFICATIONS
Power Bank
Operating Temperature -4 to 140°F (-20 to 60°C)
Start Current
Peak Current
Capacity 30,000mAh/111WH
Cycle life 1,000 times
Charge mode AC 15V/2A
USB output 5V/2.1A 5V/2.1A
DC Output 12V
800A
1800A

WARRANTY EXCLUSIONS
· If the Power Pack or any accessories have been misused, dropped,
exposed to water or damaged in any way by use outside the designed
parameters of the product.
· The use of any other jumper leads or cables other than that supplied with
this product.
· The use of damaged jumper leads.
· If the Power Pack case has attempted to be opened or has been opened
and or attempted repair.
· General mistreatment or poor care of the product.
7